RESUMEN

To control the diffusion of high concentrations of coal dust during tunnel boring and minimize the threat to the life and health of coal miners, theoretical analysis, numerical simulations, and field measurements were combined in this study. First, computational fluid dynamic simulation software was used to simulate the generation of dust particles and their transport pattern in the tunnel. Subsequently, an innovative orthogonal test was performed to study the effect of four ventilation parameters [the pressure airflow rate (Q), distance between the air duct center and heading face (LA), distance between the air duct center and tunnel floor (LB), and distance between the air duct center and nearest coal wall (LC)] on dust diffusion. According to the orthogonal test results, the optimal ventilation parameters for effective dust control are as follows: Q = 1400 m3/min, LA = 7 m, LB = 2.8 m, and LC = 1 m. The optimized set of ventilation parameters was applied to the Wangpo 3206 working face. The results show that dust diffusion in the tunnel was effectively controlled and that the air quality was sufficiently improved.

Asunto(s)

RESUMEN

The increasing level of mechanization in coal mining means more dust and gas are generated during excavation operations in tunnels. The high concentrations of dust and gas severely affect production efficiency and the physical and mental health of workers. Here, Ansys Fluent simulations were performed to derive the spatiotemporal evolution of coupled airflow-dust-gas diffusion in a low-gas excavation face. The aim was to optimize pollution control by determining the optimal duct distance, L, from the working face in the excavation tunnel. Our results showed that the airflow field affects the coupled diffusion and transport of dust and gas. According to a comparison of the effects of different duct distances from the working face, when L = 6 m, the average dust concentration in the tunnel is low (257.6 mg/m3), and the average gas concentration in the tunnel is 0.28 %, which does not exceed the safety limit. Accordingly, the optimal distance of the duct for pollution control is 6 m. The results of field measurements supported the validity of the simulation. Our findings can be used to improve the air quality in tunnels, thereby keeping miners safe and the working area clean.

RESUMEN

To solve the problem of high-concentration dust pollution in a bored tunnel, we conducted a simulation study on the dust transport law and air age of the wind flow in a bored tunnel under different ventilation methods. Air age was innovatively introduced as an index for evaluating tunnel air quality. The results show that dust pollution is serious under conditions of press-in ventilation, which is unfavorable to personnel operations. Following the installation of an on-board dust-removal fan, an effective dust-control air curtain forms in the tunnel, and the high-concentration dust is essentially controlled within the range of Z = 13 m from the working face. The dust concentration in the working area on the left side of the tunnel is CD < 200 mg/m3, and the dust-control effect is obvious. At the same time, the air age on both sides of the tunnel is reduced by 35.5% following the use of the on-board dust-removal fan. Taking into account dust control by ventilation and dust removal by fan, spraying dust reduction measures are added, and we developed automated wind-mist synergistic wet high-frequency oscillation dust-capturing technology for tunnel boring. This could effectively improve the problem of high levels of coal dust pollution in tunnels.

Asunto(s)

RESUMEN

Particulate matter (PM) is one of the most harmful exhaust pollutants to human health. In this study, the PM diffusion and distribution emitted by trackless rubber-tyred vehicle under different driving conditions in coal mine were analyzed with numerical simulations and field measurements. The results show that when the vehicle velocity was constant, the PM concentration of the trackless rubber-tyred vehicle decreased with increasing distance from the exhaust pipe orifice. In addition, the proportion of PM with a concentration below 10 mg/m3 was the highest owing to the influences of diffusion and airflow dilution. However, when the diffusion distance is less than 3 m, the PM concentration far exceeds the occupational exposure limit (10 mg/m3). In this case, underground personnel should stay away from the area near and along the exhaust pipe as far as possible. With increasing vehicle velocity, the PM concentration gradient at a diffusion distance of 0-6 m showed the most significant slope. Besides, the concentration fluctuation of PM was the largest and relatively high when the diffusion distance was 5-15 m. Therefore, the area 15 m from the exhaust gas pipe opening of the trackless rubber-tyred vehicle should be controlled. In addition, the relative errors between the measured and numerical simulation results were mostly less than 10%, which proved that the numerical simulation results were reliable.

Asunto(s)

RESUMEN

Bolter miners are being increasingly used. Unfortunately, this mining technology causes a considerable amount of air pollution (especially by methane and dust) during excavation. In this study, the multiphase coupling field of airflow-dust-methane for different distances between the pressure air outlet and the working face (Lp) was simulated by using the FLUENT software. The migration law of pollutants in the multiphase coupling field was analyzed, and the distance parameters between the pressure air outlet and the working face were optimized. Finally, the simulation results were verified based on the field measurement results. We found that the blowdown effect was more obvious when 14 m ≤ Lp < 16 m compared with other conditions. The peak value of dust concentration within this distance range was the smallest (44.4% lower than the highest peak value, which was verified when Lp = 18 m), while the methane concentration was < 0.6%. A high-concentration area (where methane concentration > 0.75%), identified near the walking part of the bolter miner, was 13 m shorter than the largest (when Lp = 18 m). Therefore, we determined that the optimal blowdown distance would be 14 m ≤ Lp < 16 m. Within this range, the dust removal and methane dilution effects are optimal, effectively improving the tunnel air quality and providing a safe and clean environment for mine workers.

Asunto(s)

RESUMEN

The high growth in the use of underground diesel vehicles has led to a large number of exhaust pollutants, especially particulate matter (PM), which is a serious threat to the lives and health of underground personnel. In this paper, based on numerical simulations and field measurements, the temporal and spatial distribution of PM in the exhaust of two vehicles and the impact on the health of underground personnel was analyzed. The results showed that in both conditions, the airflow velocity between two vehicles showed a zonal distribution, and there was an airflow vortex in the chamber under the interaction of the wind. When the vehicles were running in the same direction into the wind, PM with a concentration range of 15.79-26.32 mg/m3 could reach the height of the human respiratory belt and was mainly distributed on the east side of the roadway. Therefore, underground personnel should avoid approaching the right area of the vehicle body. In addition, PM concentration around the driver position of the vehicle was still higher than the human contact limit, so the drivers of the vehicle would need personal protection. When the vehicles were running in the same direction with the wind, compared with the airflow inlet side, the amount of PM on the airflow outlet side increased more obviously with time, especially for PM with a concentration range of 21.05-31.58 mg/m3. Also, partial PM flowed into the chamber with the airflow, such that personnel should avoid being located on the downwind side of the vehicle, and personnel in the chamber should also have personal protection.

Asunto(s)