RESUMEN
Consumer spray products release aerosols that can potentially be inhaled and reach the deep parts of the lungs. A thin layer of liquid, containing a mixture of proteins and lipids known as lung surfactant, coats the alveoli. Inhibition of lung surfactant function can lead to acute loss of lung function. We focused on two groups of spray products; 8 cleaning and 13 impregnation products, and in the context of risk assessment, used an in vitro method for assessing inhibition of lung surfactant function. Original spray-cans were used to generate aerosols to measure aerodynamic particle size distribution. We recreated a real-life exposure scenario to estimate the alveolar deposited dose. Most impregnation products inhibited lung surfactant function at the lowest aerosolization rate, whereas only two cleaning products inhibited function at the highest rates. We used inhibitory dose and estimated alveolar deposition to calculate the margin of safety (MoS). The MoS for the inhibitory products was ≤1 for the impregnation products, while much larger for the cleaning products (>880). This risk assessment focused on the risk of lung surfactant function disruption and provides knowledge on an endpoint of lung toxicity that is not investigated by the currently available OECD test guidelines.
Asunto(s)
Exposición por Inhalación , Surfactantes Pulmonares , Aerosoles/toxicidad , Excipientes , Exposición por Inhalación/efectos adversos , Exposición por Inhalación/análisis , Pulmón/metabolismo , Tamaño de la Partícula , Surfactantes Pulmonares/metabolismo , Surfactantes Pulmonares/toxicidad , Medición de Riesgo , Tensoactivos/toxicidadRESUMEN
A Near Field/Far Field (NF/FF) model is a well-accepted tool for precautionary exposure assessment but its capability to estimate particulate matter (PM) concentrations is not well studied. The main concern is related to emission source characterization which is not as well defined for PM emitters compared to e.g. for solvents. One way to characterize PM emission source strength is by using the material dustiness index which is scaled to correspond to industrial use by using modifying factors, such as handling energy factors. In this study we investigate how well the NF/FF model predicts PM concentration levels in a paint factory. PM concentration levels were measured during big bag and small bag powder pouring. Rotating drum dustiness indices were determined for the specific powders used and applied in the NF/FF model to predict mass concentrations. Modeled process specific concentration levels were adjusted to be similar to the measured concentration levels by adjusting the handling energy factor. The handling energy factors were found to vary considerably depending on the material and process even-though they have the same values as modifying factors in the exposure models. This suggests that the PM source characteristics and process-specific handling energies should be studied in more detail to improve the model-based exposure assessment.