RESUMEN
The continuous flow sample introduction technique with a hydride generator system in conjunction with an inductively coupled plasma emission spectrometer (ICP-AES-HG), is used in this study for quantitative determination of ammonium and organic bound nitrogen in aqueous and solid samples. Ammonia vapor released from ammonium salt after treatment with concentrated NaOH is transferred by argon to plasma for detection at 174.273 nm using axial argon plasma mode. The calibration curves were linear within a range of 25-1000 mg L(-1)N as ammonium molybdate with correlation coefficients of better than 0.99 and limits of detection of about 10-25mg L(-1)N. The percent recovery of N (25-500 mg L(-1)N) in soft (distilled) water and high salt content (1.7 mol L(-1) NaCl) matrices was found to be in the range of about 97-102% with %RSD in the range of 4.6-0.62. The sensitivity, limit of detection, and blank contribution from the atmospheric nitrogen, were tremendously improved in this method compared with the available ICP-AES spray chamber counterpart. Furthermore, the ICP-AES-HG method gave results for real samples (soil, fertilizer, waste water) containing about 50-1800 mg L(-1)N in good agreement with those obtained by the standard Kjeldahl method. No statistical differences at the 95% confidence level on applying the t-test were observed between the values obtained by the two methods. Thus, the ICP-AES-HG method is reliable and faster than the conventional tedious Kjeldahl method, superior to the ICP-AES spray chamber method, and almost free from matrix interference which is usually a critical factor in atomic emission spectroscopic techniques.
Asunto(s)
Nitrógeno/análisis , Compuestos de Amonio Cuaternario/análisis , Espectrofotometría Atómica/métodos , Calibración , Fertilizantes/análisis , Reproducibilidad de los Resultados , Suelo/análisis , Espectrofotometría Atómica/instrumentación , Contaminantes Químicos del Agua/análisisRESUMEN
An HPLC method was developed and validated for the determination of cetirizine dihydrochloride (CZ) as well as its related impurities in commercial oral solution and tablet formulations. Furthermore, two preservatives associated with the drug formulations, namely, propyl (PP) and butylparabens (BP) were successfully determined by this method. The chromatographic system used was equipped with a Hypersil BDS C18, 5 microm column (4.6 x 250 mm) and a detector set at 230 nm in conjunction with a mobile phase of 0.05 M dihydrogen phosphate:acetonitrile:methanol:tetrahydrofuran (12:5:2:1, v/v/v/v) at a pH of 5.5 and a flow rate of 1 ml min(-1). The calibration curves were linear within the target concentration ranges studied, namely, 2 x 10(2) - 8 x 10(2) microg ml(-1) and 1-4 microg ml(-1) for CZ, 20-100 microg ml(-1) for preservatives and 1-4 microg ml(-1) for CZ related impurities. The limits of detection (LOD) and quantitation (LOQ) for CZ were, respectively, 0.10 and 0.34 microg ml(-1) and for CZ related impurities were in the ranges of 0.08-0.26 microg ml(-1) and 0.28-0.86 microg ml(-1), respectively. The method proved to be specific, stability indicating, accurate, precise, robust and could be used as an alternative to the European pharmacopoeial method set for CZ and its related impurities.
Asunto(s)
Cetirizina/análisis , Antagonistas de los Receptores Histamínicos H1/análisis , Calibración , Cromatografía Líquida de Alta Presión , Contaminación de Medicamentos , Estabilidad de Medicamentos , Soluciones Farmacéuticas , Conservadores Farmacéuticos , Estándares de Referencia , Reproducibilidad de los Resultados , Espectrofotometría Ultravioleta , ComprimidosRESUMEN
This article studies the compatibility of amlodipine besylate in its solid formulations with various drug excipients. The various factors affecting amlodipine besylate stability were studied using high-performance liquid chromatography (HPLC). It has been found that binary 1:1 mixtures of amlodipine besylate and an excipient are stable at 65 degrees C and 40 degrees C/75% RH. Further investigations were conducted to study the stability of amlodipine besylate in multicomponent mixtures, including mixtures with actual formulations. The study reveals that mixtures of lactose, magnesium stearate, and water induce some instability on amlodipine besylate. The major degradation product confirmed by HPLC-mass spectrometry is amlodipine besylate glycosyl. This is in conformity with the well-known Maillard reaction between primary amines and lactose. Thus, lactose-free amlodipine formulations are recommended from the safety, quality, efficacy, and process cost points of view.
Asunto(s)
Amlodipino/química , Excipientes/química , Amlodipino/análisis , Amlodipino/farmacocinética , Formas de Dosificación , Interacciones Farmacológicas , Estabilidad de Medicamentos , Excipientes/análisis , Excipientes/farmacocinéticaRESUMEN
There is a lack of information concerning analysis of terbutaline sulfate and quantification of its related substances particularly in the liquid dosage forms. This work aimed at developing and validating an HPLC method for determination of terbutaline sulfate and its possible degradation products, namely, 3,5-dihydroxybenzoic acid, 3,5 dihydroxybenzaldehyde and 1-(3,5-dihydroxyphenyl)-2-[(1,1-dimethylethyl) amino]-ethanone that might appear as impurities in the starting material as well as in the solid and liquid formulations. The chromatographic system used consisted a Hypersil 100 C(18,) 150 x 4.6 mm (5 microm) column, a mobile phase of ammonium acetate (0.15 M) and glacial acetic acid (pH of 4.0, 96:4 v/v) with a flow rate of 2 ml min(-1) and a UV detector set at 270 nm. The degree of linearity and the characteristic statistical parameters of the calibration curves including the limit of detection (LOD) and limit of quantitation (LOQ) were estimated for terbutaline sulfate and its degradation products. The method was found to be specific, stability indicating, accurate, precise and robust.