RESUMEN

Calcium carbonate is a chemical compound with the formula CaCO3 formed by three main elements: carbon, oxygen, and calcium. It is a common substance found in rocks in all parts of the world (most notably as limestone), and is the main component of shells of marine organisms, snails, coal balls, pearls, and eggshells. CaCO3 exists in different polymorphs, each with specific stability that depends on a diversity of variables.

Asunto(s)

RESUMEN

The continuous flow sample introduction technique with a hydride generator system in conjunction with an inductively coupled plasma emission spectrometer (ICP-AES-HG), is used in this study for quantitative determination of ammonium and organic bound nitrogen in aqueous and solid samples. Ammonia vapor released from ammonium salt after treatment with concentrated NaOH is transferred by argon to plasma for detection at 174.273 nm using axial argon plasma mode. The calibration curves were linear within a range of 25-1000 mg L(-1)N as ammonium molybdate with correlation coefficients of better than 0.99 and limits of detection of about 10-25mg L(-1)N. The percent recovery of N (25-500 mg L(-1)N) in soft (distilled) water and high salt content (1.7 mol L(-1) NaCl) matrices was found to be in the range of about 97-102% with %RSD in the range of 4.6-0.62. The sensitivity, limit of detection, and blank contribution from the atmospheric nitrogen, were tremendously improved in this method compared with the available ICP-AES spray chamber counterpart. Furthermore, the ICP-AES-HG method gave results for real samples (soil, fertilizer, waste water) containing about 50-1800 mg L(-1)N in good agreement with those obtained by the standard Kjeldahl method. No statistical differences at the 95% confidence level on applying the t-test were observed between the values obtained by the two methods. Thus, the ICP-AES-HG method is reliable and faster than the conventional tedious Kjeldahl method, superior to the ICP-AES spray chamber method, and almost free from matrix interference which is usually a critical factor in atomic emission spectroscopic techniques.

Asunto(s)

RESUMEN

An HPLC method was developed and validated for the determination of cetirizine dihydrochloride (CZ) as well as its related impurities in commercial oral solution and tablet formulations. Furthermore, two preservatives associated with the drug formulations, namely, propyl (PP) and butylparabens (BP) were successfully determined by this method. The chromatographic system used was equipped with a Hypersil BDS C18, 5 microm column (4.6 x 250 mm) and a detector set at 230 nm in conjunction with a mobile phase of 0.05 M dihydrogen phosphate:acetonitrile:methanol:tetrahydrofuran (12:5:2:1, v/v/v/v) at a pH of 5.5 and a flow rate of 1 ml min(-1). The calibration curves were linear within the target concentration ranges studied, namely, 2 x 10(2) - 8 x 10(2) microg ml(-1) and 1-4 microg ml(-1) for CZ, 20-100 microg ml(-1) for preservatives and 1-4 microg ml(-1) for CZ related impurities. The limits of detection (LOD) and quantitation (LOQ) for CZ were, respectively, 0.10 and 0.34 microg ml(-1) and for CZ related impurities were in the ranges of 0.08-0.26 microg ml(-1) and 0.28-0.86 microg ml(-1), respectively. The method proved to be specific, stability indicating, accurate, precise, robust and could be used as an alternative to the European pharmacopoeial method set for CZ and its related impurities.

Asunto(s)

RESUMEN

This article studies the compatibility of amlodipine besylate in its solid formulations with various drug excipients. The various factors affecting amlodipine besylate stability were studied using high-performance liquid chromatography (HPLC). It has been found that binary 1:1 mixtures of amlodipine besylate and an excipient are stable at 65 degrees C and 40 degrees C/75% RH. Further investigations were conducted to study the stability of amlodipine besylate in multicomponent mixtures, including mixtures with actual formulations. The study reveals that mixtures of lactose, magnesium stearate, and water induce some instability on amlodipine besylate. The major degradation product confirmed by HPLC-mass spectrometry is amlodipine besylate glycosyl. This is in conformity with the well-known Maillard reaction between primary amines and lactose. Thus, lactose-free amlodipine formulations are recommended from the safety, quality, efficacy, and process cost points of view.

Asunto(s)

RESUMEN

There is a lack of information concerning analysis of terbutaline sulfate and quantification of its related substances particularly in the liquid dosage forms. This work aimed at developing and validating an HPLC method for determination of terbutaline sulfate and its possible degradation products, namely, 3,5-dihydroxybenzoic acid, 3,5 dihydroxybenzaldehyde and 1-(3,5-dihydroxyphenyl)-2-[(1,1-dimethylethyl) amino]-ethanone that might appear as impurities in the starting material as well as in the solid and liquid formulations. The chromatographic system used consisted a Hypersil 100 C(18,) 150 x 4.6 mm (5 microm) column, a mobile phase of ammonium acetate (0.15 M) and glacial acetic acid (pH of 4.0, 96:4 v/v) with a flow rate of 2 ml min(-1) and a UV detector set at 270 nm. The degree of linearity and the characteristic statistical parameters of the calibration curves including the limit of detection (LOD) and limit of quantitation (LOQ) were estimated for terbutaline sulfate and its degradation products. The method was found to be specific, stability indicating, accurate, precise and robust.

Asunto(s)

RESUMEN

This study aimed at developing and validating an HPLC method for the assay of sildenafil citrate and its related substances that might coexist in the drug commercial products and in tablets' formulation as impurities that originate from synthesis processes or degradation. A chromatographic system comprising a microBondapak C(18) (10 microm) column, a mobile phase of ammonium acetate (pH 7.0, 0.2 M)-acetonitrile (1:1, v/v), a flow rate of 1 ml/min and a UV detector set at 240 nm has shown good chromatographic separation for sildenfil and the other related substances. The degree of linearity of the calibration curves, the percent recoveries of sildenafil and related substances, the limit of detection, LOD, and limit of quantitation, LOQ for the HPLC method have been determined. The HPLC method under study was found to be specific, precise, accurate, reproducible indicating stability and robust.

Asunto(s)

RESUMEN

The chemical stability of enalapril maleate in tablet dosage forms consisting of different formulation excipients has been studied in this work. The influence of various parameters such as heat, moisture, light and the drug-matrix was investigated. The degradation of enalapril maleate has been followed by using an HPLC method, which was demonstrated to be specific, stability indicating, accurate and precise. The degradation kinetics of enalalpril maleate in phosphate buffer solutions of pH values in the range of 2.2-10.5 were observed to be psuedo first order throughout the whole pH range studied. Enalapril maleate alone showed high stability for temperature under dry and humid conditions, however it became unstable when mixed with the drug-matrix in its tablet formulations and exposed to the same conditions. The pathway of degradation of enalapril maleate was found to be pH dependent. The extent of degradation of two different enalapril maleate tablet formulations (product A of a basic drug-matrix and product B of an acidic drug-matrix) has been investigated. The degree of degradation of the product with acidic matrix was significantly less than that of the basic matrix under same temperature and humidity conditions. In fact, diketopiperazine and enalaprilat degradants were mainly associated with the degradation of the product with the acidic matrix and that with the basic matrix, respectively. Dry enalapril maleate powder showed some photolysis, which was more significant with daylight (3.3%) compared with that under UV light (0.2%). Although the product with the acidic matrix showed some photolysis but the effect was not pronounced and the % recovery of enalapril was almost complete and within the acceptable experimental errors. However, the product with the basic matrix showed almost no response for photolysis.

Asunto(s)

RESUMEN

Methyl-5-benzoyl-2-benzimidazole carbamate (mebendazole) is a drug used as an anthelmintic. A high performance liquid chromatography method has been developed in this study to determine mebendazole and its degradation product in the pharmaceutical dosage forms (tablets and suspension). The expected major degradation product of mebendazole in the dosage forms has been prepared, and identified as 2-amino-5-benzoylbenzimidazole. The proposed HPLC assay was found to be selective, accurate (% recoveries were in the range of 99.9-100.9) for both, mebendazole and the degradation product, repeatable and reproducible (replicate measurements for short and long term measurements showed % RSD of

RESUMEN

Polyoxyalkylene systems, namely, polypropylene glycol (PPG-1025), polyethylene glycol (PEG-600) and polybutadieneoxide (PBDO-700) dissolved in either nitrobenzene or 1,2-dichloroethane have been tested as prospective extractants for some lanthanide metal ions (Eu(3+), Pr(3+) and Er(3+)) from their aqueous solutions in the presence of picrate anions. The metal ions were quantified before and after extraction using the inductively coupled plasma emission spectrophotometry technique. The percent extraction and the distribution coefficients have indicated that pH of the aqueous phase, picrate concentration and the organic solvent are the major parameters that affect the extraction efficiency of the metal ions. The optimum pH range was found to be 3.5-5.5 and the picrate concentration should be as high as possible; however, a picrate concentration of about 0.05 M proved to be adequate for a near quantitative extraction. In all cases, nitrobenzene enhanced a higher percent extraction compared to 1,2-dichloroethane. The efficiency of the polyoxyalkylene systems to extract certain lanthanide metal ions was in the order PBDO-700>PPG-1025>PEG-600 when nitrobenzene was the organic solvent and in the order PPG-1025>PBDO-700 approximately PEG-600 when 1,2-dichloroethane used as the solvent in the organic phase. The extractability of PPG-1025 towards the lanthanide metal ions was in the order Pr(3+)>Eu(3+)>Er(3+) irrespective of the organic solvent used. The stoichiometry of the extracted polyoxyalkylene ion-pairs with the lanthanide metal ions has been estimated. Each mole of metal ions is associated with three moles of picrate anions and 13 to 14 moles of propyleneoxide units in the case of PPG-1025, and about 9 to 10 moles of ethyleneoxide units in the case of PEG-600 and 10 moles of butadieneoxide units in the case of PBDO-700.

RESUMEN

Radiotracer studies with (45)Ca, (89)Sr and (133)Ba have provided evidence that the permeation of magnesium, strontium and barium ions through PVC membranes containing Orion 92-20-02 liquid ion-exchanger is inhibited by their low affinity for the liquid ion-exchanger sites. Experiments with (7)Be indicate a strong affinity of the membrane for beryllium ions with corresponding inhibition of permeation. When acid is present in the solution on one side of the membrane, preferential permeation by protons may lead to transport of ions against their concentration gradient in order to maintain the balance of charge.