RESUMEN

This study reports measurements of the skin surface temperature elevations during localized irradiation (94 GHz) of three species: rat (irradiated on lower abdomen), rhesus monkey (posterior forelimb), and human (posterior forearm). Two exposure conditions were examined: prolonged, low power density microwaves (LPM) and short-term, high power density microwaves (HPM). Temperature histories were compared with calculations from a bio-heat transfer model. The mean peak surface temperature increase was approximately 7.0 degrees C for the short-term HPM exposures for all three species/locations, and 8.5 degrees C (monkey, human) to 10.5 degrees C (rat) for the longer-duration LPM exposures. The HPM temperature histories are in close agreement with a one-dimensional conduction heat transfer model with negligible blood flow. The LPM temperature histories were compared with calculations from the bio-heat model, evaluated for various (constant) blood flow rates. Results suggest a variable blood flow model, reflecting a dynamic thermoregulatory response, may be more suited to describing skin surface temperature response under long-duration MMW irradiation.

Asunto(s)

RESUMEN

Rapid increase in the use of numerical techniques to predict current density or specific absorption rate (SAR) in sophisticated three dimensional anatomical computer models of man and animals has resulted in the need to understand how numerical solutions of the complex electrodynamics equations match with empirical measurements. This aspect is particularly important because different numerical codes and computer models are used in research settings as a guide in designing clinical devices, telecommunication systems, and safety standards. To ensure compliance with safety guidelines during equipment design, manufacturing and maintenance, realistic and accurate models could be used as a bridge between empirical data and actual exposure conditions. Before these tools are transitioned into the hands of health safety officers and system designers, their accuracy and limitations must be verified under a variety of exposure conditions using available analytical and empirical dosimetry techniques. In this paper, empirical validation of SAR values predicted by finite difference time domain (FDTD) numerical code on sphere and rat is presented. The results of this study show a good agreement between empirical and theoretical methods and, thus, offer a relatively high confidence in SAR predictions obtained from digital anatomical models based on the FDTD numerical code.

Asunto(s)

RESUMEN

The development and widespread use of advanced three-dimensional digital anatomical models to calculate specific absorption rate (SAR) values in biological material has resulted in the need to understand how model parameters (e.g., permittivity value) affect the predicted whole-body and localized SAR values. The application of the man dosimetry model requires that permittivity values (dielectric value and conductivity) be allocated to the various tissues at all the frequencies to which the model will be exposed. In the 3-mm-resolution man model, the permittivity values for all 39 tissue-types were altered simultaneously for each orientation and applied frequency. In addition, permittivity values for muscle, fat, skin, and bone marrow were manipulated independently. The finite-difference time-domain code was used to predict localized and whole-body normalized SAR values. The model was processed in the far-field conditions at the resonant frequency (70 MHz) and above (200, 400, 918, and 2060 MHz) for E orientation. In addition, other orientations (K, H) of the model to the incident fields were used where no substantial resonant frequency exists. Variability in permittivity values did not substantially influence whole-body SAR values, while localized SAR values for individual tissues were substantially affected by these changes. Changes in permittivity had greatest effect on localized SAR values when they were low compare to the whole-body SAR value or when errors involved tissues that represent a substantial proportion of the body mass (i.e., muscle). Furthermore, we establish the partial derivative of whole-body and localized SAR values with respect to the dielectric value and conductivity for muscle independently. It was shown that uncertainties in dielectric value or conductivity do not substantially influence normalized whole-body SAR. Detailed investigation on localized SAR ratios showed that conductivity presents a more substantial factor in absorption of energy in tissues than dielectric value for almost all applied exposure conditions.

Asunto(s)

RESUMEN

Specific absorption rate (SAR) value is dependent on permittivity value. However, variability in the published permittivity values for human and animal tissue and the development of sophisticated 3-dimensional digital anatomical models to predict SAR values has resulted in the need to understand how model parameters (permittivity value) affect the predicted whole body and localized SAR values. In this paper, we establish the partial derivative of whole body SARs and localized SAR values (defined as SAR for individual organs with respect to a change in the permittivity values of all tissue types, as well as for those tissues with the most variable permittivity values. Variations in the published permittivity values may substantially influence whole body and localized SAR values, but only under special conditions. Orientation of the exposed object to the incident electromagnetic wave is one of the most crucial factors. Published 2001 Wiley-Liss, Inc.

Asunto(s)

RESUMEN

Digital anatomical models of man and animals are available for use in numerical calculations to predict electromagnetic field (EMF)-induced specific absorption rate (SAR) values. To use these models, permittivity values are assigned to the various tissues for the EMF frequencies of interest. There is, as yet, no consensus on what are the best permittivity data. This study analyzed the variability in published permittivity data and investigated the effects of permittivity values that are proportional on SAR calculations. Whole-sphere averaged and localized SAR values along the diameter of a 4-cm sphere are calculated for EMF exposures in the radio frequency range of 1 MHz to 1 GHz. When the dimensions of a sphere are small compared to the wavelength (i.e., wavelength inside the material is greater than ten times the dimensions of the object), the whole-sphere averaged SAR is inversely proportional to the permittivity of the material composing the sphere. However, the localized SAR values generally do not have the same relation and, as a matter of fact, vary greatly depending on the location within the sphere. These results indicate that care must be taken in choosing the permittivity values used in calculating SAR values and some estimate of the dependence of the calculated SAR values on variability in permittivity should be determined.

Asunto(s)

RESUMEN

Exposure to fast-rise-time ultra-wideband (UWB) electromagnetic pulses has been postulated to result in effects on biological tissue (including the cardiovascular system). In the current study, 10 anesthetized Sprague-Dawley rats were exposed to pulses produced by a Sandia UWB pulse generator (average values of exposures over three different pulse repetition rates: rise time, 174-218 ps; peak E field, 87-104 kV/m; pulse duration, 0.97-0.99 ns). Exposures to 50, 500 and 1000 pulses/s resulted in no significant changes in heart rate or mean arterial blood pressure measured every 30 s during 2 min of exposure and for 2 min after the exposure. The results suggest that acute UWB whole-body exposure under these conditions does not have an immediate detrimental effect on these cardiovascular system variables in anesthetized rats.

Asunto(s)

RESUMEN

We measured thresholds for microwave-evoked skin sensations of warmth at frequencies of 2.45, 7.5, 10, 35, and 94 GHz. In the same subjects, thresholds of warmth evoked by infrared radiation (IR) were also measured for comparison. Detection thresholds were measured on the skin in the middle of the back in 15 adult male human subjects at all microwave (MW) frequencies and with IR. Long duration (10-s), large area (327-cm2) stimuli were used to minimize any differential effects of temporal or spatial summation. Sensitivity increased monotonically with frequency throughout the range of microwave frequencies tested. The threshold at 94 GHz (4.5 +/- 0.6 mW/cm2) was more than an order of magnitude less than at 2.45 GHz (63.1 +/- 6.7 mW/cm2), and it was comparable to the threshold for IR (5.34 +/- 1.07 mW/cm2).

Asunto(s)

RESUMEN

Development of new emitter systems capable of producing high-peak-power electromagnetic pulses with very fast rise times and narrow pulse widths is continuing. Such directed energy weapons systems will be used in the future to defeat electronically vulnerable targets. Human exposures to these pulses can be expected during testing and operations. Development of these technologies for radar and communications purposes has the potential for wider environmental exposure, as well. Current IEEE C95.1-1991 human exposure guidelines do not specifically address these types of pulses, though limits are stated for pulsed emissions. The process for developing standards includes an evaluation of the relevant bioeffects data base. A recommendation has been made that human exposure to ultrashort electromagnetic pulses that engender electromagnetic transients, called precursor waves, should be avoided. Studies that purport to show the potential for tissue damage induced by such pulses were described. The studies cited in support of the recommendation were not relevant to the issues of tissue damage by propagated pulses. A number of investigations are cited in this review that directly address the biological effects of electromagnetic pulses. These studies have not shown evidence of tissue damage as a result of exposure to high-peak-power pulsed microwaves. It is our opinion that the current guidelines are sufficiently protective for human exposure to these pulses.

Asunto(s)

RESUMEN

To ascertain whether behavioral effects of benzodiazepines are altered by exposure to microwave radiation, we compared the performance of male, Swiss CD1 mice in the staircase test 30 min after pretreatment with chlordiazepoxide (8, 16, and 32 mg/kg, IP) and immediately following a 5-min exposure to microwave radiation (4, 12, and 36 W/kg, continuous wave, 1.8 or 4.7 GHz). In this paradigm, chlordiazepoxide reduction in the number of rears (NR) and number of steps ascended (NSA) is postulated to reflect anxiolytic and sedative drug effects, respectively. In sham-exposed mice, increasing doses of chlordiazepoxide increased NSA without affecting NR, increased NSA and decreased NR, then decreased both NSA and NR. Microwave exposure generally did not alter NSA or NR in mice pretreated with lower doses of chlordiazepoxide. However, in mice pretreated with 32 mg/kg chlordiazepoxide, exposure to 36 W/kg microwave radiation significantly reversed the reductions in NSA and NR at 4.7 GHz but not at 1.8 GHz. These findings indicate that exposure to microwave radiation can selectively alter effects of chlordiazepoxide in this psychopharmacological paradigm.

Asunto(s)

Asunto(s)

RESUMEN

Meaningful evaluation of physiological changes resulting from microwave/radiofrequency radiation (MW/RFR) exposure depends upon accurate dose level determination. Comparison of experimental results from different investigators also requires firm establishment of dose levels. Review of the current literature reveals considerable inconsistency in this area. Therefore, a reliable method of specific absorption rate (SAR) determination in living animals must be established. In this article, we propose a new procedure for SAR determination which does not interfere with other complementary measurements required during experimentation. This simple and reliable method utilizes both the rate of temperature increase during irradiation and the rate of cooling following exposure. Current experiments suggest that the proposed method is an effective technique for local and whole-body SAR determination and allows an accurate evaluation of MW/RFR bio-effects.

Asunto(s)

Asunto(s)

Asunto(s)

Asunto(s)