RESUMEN
Although thin-film composite membranes have achieved great success in CO2 separation, further improvements in the CO2 permeance are required to reduce the size and cost of the CO2 separation process. Herein, we report the fabrication of composite membranes with high CO2 permeability using a laser-patterned porous membrane as the support membrane. High-aspect-ratio micropatterns with well-defined micropores on their surface were carved on microporous polymer supports by a direct laser writing process using a short-pulsed laser. By using a Galvano scanner and optimizing the laser conditions and target materials, in-plane micropatterns, such as microhole arrays, microline grating, microlattices, and out-of-plane hierarchical micropatterns, were created on porous membranes. An aqueous suspension of hydrogel microparticles doped with an amine-based mobile carrier was sprayed onto the patterned surface to form a defect-free thin separation layer. The surface area of the separation layer on the patterned support is up to 80% larger than that of flat pristine membranes, resulting in a 52% higher CO2 permeance (1106 GPU) with a CO2/N2 selectivity of 172. The laser-patterned porous membranes allow the development of inexpensive and high-performance functional membranes not only for CO2 separation but also for other applications, such as water treatment, cell culture, micro-TAS, and membrane reactors.
RESUMEN
The development of robust and thin CO2 separation membranes that allow fast and selective permeation of CO2 will be crucial for rebalancing the global carbon cycle. Hydrogels are attractive membrane materials because of their tunable chemical properties and exceptionally high diffusion coefficients for solutes. However, their fragility prevents the fabrication of thin defect-free membranes suitable for gas separation. Here, we report the assembly of defect-free hydrogel nanomembranes for CO2 separation. Such membranes can be prepared by coating an aqueous suspension of colloidal hydrogel microparticles (microgels) onto a flat, rough, or micropatterned porous support as long as the pores are hydrophilic and the pore size is smaller than the diameter of the microgels. The deformability of the microgel particles enables the autonomous assembly of defect-free 30-50 nm-thick membrane layers from deformed â¼15 nm-thick discoidal particles. Microscopic analysis established that the penetration of water into the pores driven by capillary force assists the assembly of a defect-free dense hydrogel layer on the pores. Although the dried films did not show significant CO2 permeance even in the presence of amine groups, the permeance dramatically increased when the membranes are adequately hydrated to form a hydrogel. This result indicated the importance of free water in the membranes to achieve fast diffusion of bicarbonate ions. The hydrogel nanomembranes consisting of amine-containing microgel particles show selective CO2 permeation (850 GPU, αCO2/N2 = 25) against post-combustion gases. Acid-containing microgel membranes doped with amines show highly selective CO2 permeation against post-combustion gases (1010 GPU, αCO2/N2 = 216) and direct air capture (1270 GPU, αCO2/N2 = 2380). The membrane formation mechanism reported in this paper will provide insights into the self-assembly of soft matters. Furthermore, the versatile strategy of fabricating hydrogel nanomembranes by the autonomous assembly of deformable microgels will enable the large-scale manufacturing of high-performance separation membranes, allowing low-cost carbon capture from post-combustion gases and atmospheric air.