RESUMEN

Photonic crystal fiber (PCF) designs with two zero-dispersion wavelengths (ZDWs) are experimentally investigated in order to suggest a novel PCF for coherent anti-Stokes Raman scattering (CARS) microscopy. From our investigation, we select the optimum PCF design and demonstrate a tailored spectrum with power concentrated around the relevant wavelengths for lipid imaging (648 nm and 1027 nm). This new PCF is characterized by varying the fiber length, the average power, and the pulse width of the fs pump pulses. It was found that the selected PCF design gave a significantly improved spectral distribution compared to an existing PCF for CARS microscopy. Furthermore, the PCF is designed in a twofold symmetric structure allowing for polarization maintaining propagation. Finally, the pulse propagation is investigated numerically showing good agreement with the measured spectrum. From the numerical analysis, the nonlinear effects responsible for the spectral broadening are explained to be soliton fission processes, dispersive waves, and stimulated Raman scattering.

Asunto(s)

RESUMEN

While swept source optical coherence tomography (OCT) in the 1050 nm range is promising for retinal imaging, there are certain challenges. Conventional semiconductor gain media have limited output power, and the performance of high-speed Fourier domain mode-locked (FDML) lasers suffers from chromatic dispersion in standard optical fiber. We developed a novel light source with a tapered amplifier as gain medium, and investigated the FDML performance comparing two fiber delay lines with different dispersion properties. We introduced an additional gain element into the resonator, and thereby achieved stable FDML operation, exploiting the full bandwidth of the tapered amplifier despite high dispersion. The light source operates at a repetition rate of 116 kHz with an effective average output power in excess of 30 mW. With a total sweep range of 70 nm, we achieved an axial resolution of 15 microm in air (approximately 11 microm in tissue) in OCT measurements. As our work shows, tapered amplifiers are suitable gain media for swept sources at 1050 nm with increased output power, while high gain counteracts dispersion effects in an FDML laser.

Asunto(s)

RESUMEN

We demonstrate electrical tunability of a fiber laser using a liquid crystal photonic bandgap fiber. Tuning of the laser is achieved by combining the wavelength filtering effect of a tunable liquid crystal photonic bandgap fiber device with an ytterbium-doped photonic crystal fiber. We fabricate an all-spliced laser cavity based on the liquid crystal photonic bandgap fiber mounted on a silicon assembly, a pump/signal combiner with single-mode signal feed-through and an ytterbium-doped photonic crystal fiber. The laser cavity produces a single-mode output and is tuned in the range 1040-1065 nm by applying an electric field to the silicon assembly.

RESUMEN

We experimentally study the generation of broadband light at approximately 1300 nm from an 810 nm Ti:sapphire femtosecond pump laser. We use two photonic crystal fibers with a second infrared zero-dispersion wavelength (lambda Z2) and compare the efficiency of two schemes: in one fiber lambda Z2=1400 nm and the light at 1300 nm is composed of spectrally recoiled solitons; in the other fiber lambda Z2=1200 nm and the light at 1300 nm is composed of dispersive waves.

RESUMEN

We present the use of a photonic crystal fiber to straightforwardly compress ultrashort pulses from a diode-pumped ytterbium laser emitting around 1 microm. 75-fs pulse generation and a large 1-1.3-microm tunability for sub-100-fs pulses is reported.

RESUMEN

We address the long-standing unresolved problem concerning the V parameter in a photonic crystal fiber. In formulating the parameter appropriate for a core defect in a periodic structure, we argue that the multimode cutoff occurs at a wavelength lambda* that satisfies VPCF(lambda*) = pi. By comparing this approach with numerics and recent cutoff calculations we confirm this result.

RESUMEN

Modal cutoff is investigated experimentally in a series of high-quality nonlinear photonic crystal fibers. We demonstrate a suitable measurement technique with which to determine the cutoff wavelength and verify the technique by inspecting the near field of the modes that may be excited below and above the cutoff. We observe a double-peak structure in the cutoff spectra, which is attributed to splitting of the higher-order modes. The cutoff is measured for seven different fiber geometries with different pitches and relative hole sizes, and very good agreement with recent theoretical work is found.