RESUMEN
A series of CdSe quantum dot acceptors possessing six different ligand frameworks (i.e., pivalic acid, pyridine, butylamine, tert-butylthiol, thiophenol, and tetrahydrothiophene) were used as platforms for investigating the influence of quantum dot surface chemistry on the performance of hybrid poly(3-hexythiophene-2,5-diyl) (P3HT):CdSe quantum dot bulk heterojunction (BHJ) solar cells. We confirm that the device parameters used to evaluate solar cell performance are significantly influenced by the nature of the quantum dot surface ligand. The dependence of short circuit current density (JSC) on the CdSe ligand type was probed using ultrafast time-resolved photoluminescence (PL) measurements, and good correlations between the ligand-dependent trends in JSC and excited state lifetime were found, in which the P3HT:CdSe quantum dot BHJs with the shortest PL lifetimes possess the largest device current densities. The frontier energy levels of the quantum dot acceptors are significantly influenced by surface ligands, wherein the device open circuit potentials (VOC) were found to linearly correlate with the energy difference (ΔEDA) between the HOMO of the P3HT donor and the electrochemically determined LUMO of the CdSe quantum dot acceptors over a range of 220 mV. This work demonstrates the versatility of quantum dot ligand engineering for tuning the device parameters and performance of hybrid solar cells.
RESUMEN
A series of compositionally complex scheelite-structured nanocrystals of the formula A1-xAWO4 (A = Ca, Sr, Ba) have been prepared under benign synthesis conditions using the vapor diffusion sol-gel method. Discrete nanocrystals with sub-20 nm mean diameters were obtained after kinetically controlled hydrolysis and polycondensation at room temperature, followed by composition-dependent thermal aging at or below 60 °C. Rietveld analysis of X-ray diffraction data and Raman spectroscopy verified the synthesis of continuous and phase-pure nanocrystal solid solutions across the entire composition space for A1-xAWO4, where 0 ≤ x ≤ 1. Elemental analysis by X-ray photoelectron and inductively coupled plasma-atomic emission spectroscopies demonstrated excellent agreement between the nominal and experimentally determined elemental stoichiometries, while energy dispersive X-ray spectroscopy illustrated good spatial elemental homogeneity within these nanocrystals synthesized under benign conditions.
RESUMEN
Nickel(II) oxide (NiO) is an important wide gap p-type semiconductor used as a hole transport material for dye sensitized solar cells and as a water oxidation electrocatalyst. Here we demonstrate that nanocrystals of the material have increased p-type character and improved photocatalytic activity for hydrogen evolution from water in the presence of methanol as sacrificial electron donor. NiO nanocrystals were synthesized by hydrolysis of Ni(II) nitrate under hydrothermal conditions followed by calcination in air. The crystals have the rock salt structure type and adopt a plate-like morphology (50-90 nm × 10-15 nm). Diffuse reflectance absorbance spectra indicate a band gap of 3.45 eV, similar to bulk NiO. Photoelectrochemical measurements were performed at neutral pH with methylviologen as electron acceptor, revealing photo-onset potentials (Fermi energies) of 0.2 and 0.05 eV (NHE) for nanoscale and bulk NiO, respectively. Nano-NiO and NiO-Pt composites obtained by photodepositon of H2PtCl6 catalyze hydrogen evolution from aqueous methanol at rates of 0.8 and 4.5 µmol H2 h(-1), respectively, compared to 0.5 and 2.1 µmol H2 h(-1) for bulk-NiO and NiO-Pt (20 mg of catalyst, 300 W Xe lamp). Surface photovoltage spectroscopy of NiO and NiO-Pt films on Au substrates indicate a metal Pt-NiO junction with 30 mV photovoltage that promotes carrier separation. The increased photocatalytic and photoelectrochemical performance of nano-NiO is due to improved minority carrier extraction and increased p-type character, as deduced from Mott-Schottky plots, optical absorbance, and X-ray photoelectron spectroscopy data.
RESUMEN
Tandem and triple-junction polymer:nanocrystal hybrid solar cells with identical subcells based on P3HT:CdSe nanocrystal bulk heterojunctions (BHJs) are reported for the first time showing 2-fold and 3-fold increases of open-circuit voltage (VOC), respectively, relative to the single-junction cell. A combination of nanocrystalline ZnO and pH-neutral PEDOT:PSS is used as the interconnecting layer, and the thicknesses of subcells are optimized with the guidance of optical simulations. As a result, the average power conversion efficiency (PCE) exhibits a significant increase from 2.0% (VOC = 0.57 V) in single-junction devices to 2.7% (champion 3.1%, VOC = 1.28 V) in tandem devices and 2.3% (VOC = 1.98 V) in triple-junction devices.
RESUMEN
We have employed a simple modular approach to install small chalcogenol ligands on the surface of CdSe nanocrystals. This versatile modification strategy provides access to thiol, selenol, and tellurol ligand sets via the in situ reduction of R2E2 (R=tBu, Bn, Ph; E=S, Se, Te) by diphenylphosphine (Ph2PH). The ligand exchange chemistry was analyzed by solution NMR spectroscopy, which reveals that reduction of the R2E2 precursors by Ph2PH directly yields active chalcogenol ligands that subsequently bind to the surface of the CdSe nanocrystals. Thermogravimetric analysis, FT-IR spectroscopy, and energy dispersive X-ray spectroscopy provide further evidence for chalcogenol addition to the CdSe surface with a concomitant reduction in overall organic content from the displacement of native ligands. Time-resolved and low temperature photoluminescence measurements showed that all of the phenylchalcogenol ligands rapidly quench the photoluminescence by hole localization onto the ligand. Selenol and tellurol ligands exhibit a larger driving force for hole transfer than thiol ligands and therefore quench the photoluminescence more efficiently. The hole transfer process could lead to engineering long-lived, partially separated excited states.
RESUMEN
Ultrafast transient absorption spectroscopy is used to study charge transfer dynamics in hybrid films composed of the low band gap polymer PCPDTBT and CdSe quantum dots capped with tert-butylthiol ligands. By selectively exciting the polymer, a spectral signature for electrons on the quantum dots appears on ultrafast time scales (â² 65 fs), which indicates ultrafast electron transfer. From this time scale, the coupling between the polymer chains and the quantum dots is estimated to be J â³ 17 meV. The reduced quantum dot acceptors exhibit an unambiguous spectral bleach signature, whose amplitude allows for the first direct calculation of the absolute electron transfer yield in a hybrid solar cell (82 ± 5%). We also show that a limitation of the hybrid system is rapid and measurable geminate recombination due to the small separation of the initial charge pair. The fast recombination is consistent with the internal quantum efficiency of the corresponding solar cell. We therefore have identified and quantified a main loss mechanism in this type of third generation solar cell.
RESUMEN
Hybrid solar cells with tert-butylthiol exchanged CdSe multipod acceptors and novel semi-random P3HTT-DPP and alternating PCDTBT copolymer donors were studied, giving high performance devices with power conversion efficiencies >3%.
RESUMEN
Organic ligands have the potential to contribute to the reduction potential, or lowest unoccupied molecular orbital (LUMO) energy, of semiconductor nanocrystals. Rationally introducing small, strongly binding, electron-donating ligands should enable improvement in the open circuit potential of hybrid organic/inorganic solar cells by raising the LUMO energy level of the nanocrystal acceptor phase and thereby increasing the energy offset from the polymer highest occupied molecular orbital (HOMO). Hybrid organic/inorganic solar cells fabricated from blends of tert-butylthiol-treated CdSe nanocrystals and poly(3-hexylthiophene) (P3HT) achieved power conversion efficiencies of 1.9%. Compared to devices made from pyridine-treated and nonligand exchanged CdSe, the thiol-treated CdSe nanocrystals are found to consistently exhibit the highest open circuit potentials with V(OC) = 0.80 V. Electrochemical determination of LUMO levels using cyclic voltammetry and spectroelectrochemistry suggest that the thiol-treated CdSe nanocrystals possess the highest lying LUMO of the three, which translates to the highest open circuit potential. Steady-state and time-resolved photoluminescence quenching experiments on P3HT:CdSe films provide insight into how the thiol-treated CdSe nanocrystals also achieve greater current densities in devices relative to pyridine-treated nanocrystals, which are thought to contain a higher density of surface traps.
RESUMEN
A new wurtzite phase of copper tin selenide (CTSe) was discovered, and the resulting nanocrystals were synthesized via a facile solution-phase method. The wurtzite CTSe nanocrystals were synthesized with dodecylamine and 1-dodecanethiol as coordinating solvents and di-tert-butyl diselenide ((t)Bu(2)Se(2)) as the selenium source. Specific reaction control (i.e., a combination of 1-dodecanethiol with (t)Bu(2)Se(2)) was proven to be critical in order to obtain this new phase of CTSe, which was verified by powder X-ray diffraction and selected area electron diffraction. The wurtzite CTSe nanocrystals possess an optical and electrochemical band gap of 1.7 eV and display an electrochemical photoresponse indicative of a p-type semiconductor.
RESUMEN
PAMAM dendrimer monolayers, immobilized on glass and modified with Ni(II)-NTA moieties at the termini, show generational dependent responses as histidine selective sensors via indicator displacement assays.