RESUMEN

Thermal barrier coating (TBC) systems are widely adopted in gas turbine blades to improve the thermal efficiency of gas turbine engines. However, TBC failure will happen due to the thermal stress between the different layers of the TBC systems. The traditional two-layer theoretical model only considers TGO (thermally grown oxide) and a substrate in the inner cooling hole with the surface uncoated, which results in poor prediction of the deformations of the TBC systems. It should be mentioned that the effect of TBC is very important because the thickness of TBC is much larger than the TGO thickness. In this study, a new three-layer theoretical model was derived, which is composed of the cylindrical TGO and TBC mounted in the substrate with a circular hole, and the stress and strain of TGO near the cooling hole under the condition of the thermal cycles were calculated. The high temperature characteristics of TGO and the substrate including the high temperature strength and growth ratio were from the experiments. The results show that the strain of the developed three-layer model is irrelevant with increasing number of cycles, which indicates that TBC in the cooling hole significantly inhibits the deformation of TGO near the cooling hole. Therefore, aimed at confirming the feasibility of the three-layer theoretical model, the finite element analysis with coating in the cooling hole and on the surface was carried out with a three-layer axisymmetric model, which proves that the 3-layer theoretical model can predict the deformation trend near the cooling hole.

RESUMEN

The interfacial properties of a heterogeneous composite flooding system containing a surfactant fatty alcohol polyoxyethylene carboxylate (C12EO3C), branched-preformed particle gel (B-PPG), and polymer partly hydrolyzed polyacrylamide (HPAM) at the crude oil-water interface were investigated by a dilational rheology method. The results demonstrated that the C12EO3C molecules can form an elastic interfacial film with certain strength at the crude oil-water interface. The addition of HPAM to the C12EO3C solution has a detrimental effect on the interfacial film formed by C12EO3C molecules, leading to a decrease in the dilational modulus and an increase in the phase angle. Moreover, the addition of B-PPG to the C12EO3C solution also disrupts the stability and strength of the interfacial film of C12EO3C. In particular, linear HPAM with a lower steric hindrance is more likely to insert into the interfacial film of C12EO3C; thus, HPAM possesses a stronger destruction ability for the interfacial film of C12EO3C than B-PPG. When HPAM is compounded with B-PPG, a superimposed effect exists to cause more severe disruption for the interfacial film. The heterogeneous composite flooding system not only enhances oil recovery by increasing the viscosity of the bulk phase but also weakens the interfacial film to facilitate the post-treatment of the recovered crude oil. Thus, the heterogeneous composite flooding system exhibits promising prospects in practical application.

RESUMEN

Taking naturally growing grass (NG) as comparison, high-throughput sequencing technique was adopted to examine the effects of Lolium perenne (LP), Trifolium repens (TR), Vulpia myuros (VM), and Vicia villosa (VV) cultivation on soil microbial community in apple orchard of Yanggu County, Shandong Province, and the correlations of soil microbial community with soil nutrient and physicochemical property. The results showed that LP increased the relative abundance of Alternaria and Aspergillus in soil, TR increased that of Gibberella, VM increased Aureobasidium and Chaetomium, and VV increased probiotics such as Nitrososophaera and Metarhizium. However, the quantity of pathogenic bacteria Ralstonia was improved in NG treatment. Results from Spearman correlation analysis showed that the abundance of Bacillus was significantly positively correlated with the concentration of soil organic matter. The abundance of Aspergillus was significantly negatively correlated with available phosphorus, available potassium, CEC, and organic matter. The abundance of Metarhizium was significantly positively correlated with soil pH and CEC. Planting VV between rows of apple orchards, and enhancing the soil organic matter and nutrients content in a certain extent, helped to improve soil micro-ecological environment.

Asunto(s)

RESUMEN

The contact angle measurements for the aqueous solutions of two pairs of zwitterions on quartz surfaces have been investigated by the sessile drop analysis. The different physicochemical parameters such as the critical micelle concentration (CMC), surface tension, contact angle, surface excess on air-liquid and solid-liquid interfaces and work of adhesion have been estimated. The obtained results show that the contact angle of surfactants such as alkyl carboxylbetaine (ACB) and ditolyl substituted alkyl carboxylbetaine (BCB) remains almost constant in a wide range of surfactant concentration and increases gradually above CMC, which are quite different from traditional surfactants reported in the literature. Surfactants with bigger polar groups have a more steric effect on the quartz surface and the contact angle remains relatively unchanged. Moreover, an increase in quartz-liquid interfacial tension (γSL) has been observed due to the adsorption of four zwitterionic surfactants. Especially for ACB and BCB, at the surfactant concentrations higher than 5 × 10(-5) mol L(-1), a moderate increase in the interfacial tension of the quartz-liquid is observed, which suggests that ACB and BCB can form a saturated adsorption film briefly on the quartz surface and then adsorb again. However, the addition of alkyl sulfobetaine (ASB) and ditolyl substituted alkyl sulfobetaine (BSB) after CMC cannot adsorb on the quartz surface again due to the steric effect of bigger polar groups.

RESUMEN

In order to gain better understanding of the oviposition preference of Grapholitha molesta, we studied the ovipositional preference on different host fruit leaves, different parts of peach bran- ches and different varieties of peach in simulated outdoor conditions. The adult ovipositional preference on the host fruit leaves was in descending order, i. e. peach > cherry > apple > plum > pear > crabapple > apricot, and 33.5% of eggs were laid on the peach leaves with the average number of egg on one peach leaf being 8.3. There were differences in egg distribution on both sides of the leaves in different hosts. The number of egg laid on the positive surface was more than on the reverse surface of apple and crabapple leaves, and vice versus for peach, plum, pear and apricot leaves, and 3.3 times more eggs were laid on the reverse surface of peach leaves than on the positive surface. The egg distribution had no significant difference on both sides of cherry leaves. The adult ovipositional preference on peach branches was in descending order of leaf > stipule > petiole > branch. The leaves were the major ovipositonal places with 88.7% of total eggs on. 72.5% of eggs were laid on the 10 leaves near the top unexpanded leaflets, and the maximum number was on the 3rd leaf accounting for 9.3%, while only 1.1% of eggs were laid on the peach leaves after 25th. The ovipositional preference on different peach fruits was in descending order of nectarine > flat peach > prunus persica. The density and characteristics of the hair on host fruits and leaves were the primary factors affecting the ovipositional preference.

Asunto(s)

RESUMEN

The dilational rheological properties of absorbed film of three pairs of structural isomers, tri-substituted alkyl benzene sulfonates, at the air-water and decane-water interfaces have been investigated by drop shape analysis method. The influences of bulk concentration on dilational elasticity and viscosity were expounded. Interfacial tension relaxation method was employed to obtain dilational parameters in a reasonably broad frequency range. The experimental results showed that the meta-alkyl to sulfonate group plays a crucial role in the interfacial dilational properties: the longer meta-alkyl will lead to higher dilational parameters for air-water interface and lower ones for decane-water interface when the total alkyl carbon numbers are equal. For alkyl benzene sulfonates with shorter meta-alkyl, the surface dilational properties are similar to interfacial dilational properties, whereas the surface dilational parameters are obviously higher than the interfacial dilational parameters for alkyl benzene sulfonates with longer meta-alkyl in general. The possible mechanism has been proposed and ensured by Cole-Cole plots.