RESUMEN
OBJECTIVE: To compare the shaping ability of the XP-endo Shaper (XPS) system to the ProTaper Next (PTN) system in oval-shaped distal root canals. METHODS: From 12 mandibular molars, distal roots with moderately curved single oval canals were randomly assorted to be instrumented with XPS (experimental group) or PTN (control group) and then scanned using micro-computed tomography [Scan 1]. The root canals of the XPS samples were prepared following the manufacturer's instructions using 15 insertions (XPS15) and rescanned [Scan 2]. An additional 10 insertions to the working length were applied, totalling 25 insertions (XPS25), and the roots were rescanned again [Scan 3]. PTN samples were prepared up to the X3 instrument (PTNX3) and rescanned [Scan 2]. The dentine removed and the unprepared areas were assessed. Data were analysed using a t-test with significance at α=0.05. RESULTS: XPS25 was associated with a significantly greater dentine removal than XPS15 over the entire root canal length and in all three-thirds of the root canal (P<0.05). XPS25 significantly removed more dentine than PTNX3 in only the coronal third (P<0.05). XPS25 was also associated with a significantly smaller percentage of unprepared areas than XPS15 overall and in the coronal third (P<0.05). PTNX3 was associated with a significantly larger percentage of unprepared areas than XPS15 and XPS25 overall and in the coronal and middle thirds (P<0.05). CONCLUSION: Ten additional movements with XPS significantly improved instrumentation capacity, reducing the percentage of untouched surface areas but also removing more dentine.