RESUMEN

The influence of various factors on the removal efficiency of selected pharmaceuticals by membrane filtration was investigated. Several commercial polymer membranes were used for nanofiltration (NF) from various manufacturers. The studies were conducted for ibuprofen (IBF), amoxicillin (AMX), diclofenac (DCF), tetracycline (TRC), salicylic acid (SA) and acetylsalicylic acid (ASA). The influence of the structure and properties of the tested compounds on the retention coefficient and filtration rate was investigated. The influence of pH on the filtration parameters was also checked. The properties of selected membranes influencing the retention of pharmaceuticals and filtrate flux were analysed. An extensive analysis of the retention coefficients dependence on the contact angle and surface free energy was performed. It was found that there is a correlation between the hydrophilicity of the membrane and the effectiveness and efficiency of the membrane. As the contact angle of membrane increased, the flow rate of the filtrate stream increased, while the retention coefficient decreased. The studies showed that the best separation efficiency was achieved for compounds with a molecular weight (MW) greater than 300 g/mol. During the filtration of pharmaceuticals with MW ranging from 300 to 450 g/mol, the type of membrane used practically did not affect the filtration efficiency and a high degree of retention was achieved. In the case of low MW molecules (SA and ASA), a significant decrease in the separation efficiency during the process was noted.

RESUMEN

This article presents the results of studies on the degradation of ibuprofen transformation products: 1-hydroxyibuprofen (1OHIBF), 4-ethylbenzaldehyde (4EBA), 1-[4-(2-methylpropyl)phenyl]ethan-1-ol (MPPE) in water. To the best of our knowledge, this is the first paper where the ozonation and photodegradation (VIS and UV photolysis, degradation in H2O2/UV system, photosensitized oxidation) of 1OHIBF, 4EBA and MPPE are reported. The processes were performed in demineralized and natural river water. The influence of various reaction parameters on the removal degree was checked. Both, photolysis under VIS light and photosensitized oxidation of target compounds are very low-efficient processes. Ozonation and degradation in H2O2/UV system are effective methods for ibuprofen derivatives degradation. Components present in river water reduced removal degree of investigated compounds during ozonation and degradation in H2O2/UV system. The biodegradability assessment using the Average Oxidation State (AOS) and COD/TOC ratio proved the formation of more oxidized by-products during both processes. The determined second-order rate constants for ozone reaction with 1OHIBF, 4EBA and MPPE are 0.1 ± 0.01, 10.95 ± 1.36 and 3.04 ± 0.33 M-1 s-1, respectively. The calculated reaction rate constants of hydroxyl radicals with MPPE, 4EBA and 1OHIBF are 3.57 × 109, 6.83 × 109 and 1.06 × 109 M-1 s-1, respectively.

Asunto(s)

RESUMEN

The research covered the process of nanofiltration of low molecular weight organic compounds in aqueous solution. The article presents the results of experiments on membrane filtration of compounds containing amino groups in the aromatic ring and comparing them with the results for compounds without amino groups. The research was carried out for several commercial polymer membranes: HL, TS40, TS80, DL from various manufacturers. It has been shown that the presence of the amino group and its position in relation to the carboxyl group in the molecule affects the retention in the nanofiltration process. The research also included the oxidation products of selected pharmaceuticals. It has been shown that 4-Amino-3,5-dichlorophenol-a oxidation product of diclofenac and 4-ethylbenzaldehyde-a oxidation product of IBU, show poor separation efficiency on the selected commercial membranes, regardless of the pH value and the presence of natural organic matter (NOM). It has been shown that pre-ozonation of natural river water can improve the retention of pollutants removed.

RESUMEN

The main objective of this study was to develop the treatment system to change wastewater into a reliable source of recyclable water within the textile plant. Therefore, a highly polluted industrial wastewater originated in the dyeing of cotton was subjected to a multi-step treatment. The raw wastewater was characterized by the concentration of Reactive Black 5, the azo dye, as high as 842 mg/L, extreme alkalinity (pH 11.26) and salinity (NaCl concentration 52,290 mg/L). Correspondingly, the chemical oxygen demand (COD) was equal to 3440 mg/L and the total organic carbon (TOC) was 1790 mg/L in this wastewater. This salty, hardly degradable wastewater underwent the electrocoagulation (EC) on an industrial scale in the first step of the treatment. Although the industrial EC resulted in 84% of color removal in a very short time of 8 min, the wastewater was still characterized by an extremally high absorbance which corresponded to 100 mg/L of RB5. Moreover, EC resulted in the occurrence of burdensome by-products, of which one was identified in this study as an aniline derivative. The by-products contributed to high residual COD and TOC after EC (2120 mg/L and 1052 mg/L, respectively). Consequently, the catalytic ozonation was used by us as a second, the polishing, step of the treatment. The catalytic ozonation was found efficient in the removal of the residual color and colorless by-products. The wastewater after catalytic ozonation was colorless and the final COD and TOC decreased to 1283 and 695 mg/L, respectively. The average oxidation state (AOS), spectra analysis, and the toxicity assay showed catalytic ozonation efficient in the by-products oxidation. Consequently, the catalytic action of activated carbon (AC) was proved for the ozonation of textile wastewater. Ultimately, the recycling of purified wastewater into dyeing resulted in a very good color quality of textile samples (DECMC values below limiting value equal to 1.0).

Asunto(s)

RESUMEN

It is well established that aquatic wildlife in marine and freshwater of the European Union is exposed to natural and synthetic endocrine disruptor compounds (EDCs) which are able to interfere with the hormonal system causing adverse effects on the intact physiology of organisms. The traditional wastewater treatment processes are inefficient on the removal of EDCs in low concentration. Moreover, not only the efficiency of treatment must be considered but also toxicological aspects. Taking into account all these aspects, the main goal of the study was to investigate the photochemical decomposition of hazardous phenolic compounds under simulated as well as natural sunlight from the toxicity point of view. The studies were focused on photodegradation of 2,4-dichlorophenol as well as mixture of phenol, 2-chlorophenol and 2,4-dichlorophenol. Photosensitized oxidation process was carried out in homogeneous and heterogeneous system. V. fischeri luminescence inhibition was used to determine the changes of toxicity in mixture during simulated and natural irradiation. The photodegradation was carried out in three kinds of water matrix; moreover, the influence of presence of inorganic matter on the treatment process was investigated. The experiments with natural sunlight proved applicability of photosensitive chitosan for visible-light water pollutant degradation. The results of toxicity investigation show that using photosensitive chitosan for visible-light, the toxicity of reaction mixture towards V. fischeri has significantly decreased. The EC50 was found to increase over the irradiation time; this increase was not proportional to the transformation of the parent compounds.

Asunto(s)