RESUMEN
Normal and high amylose corn starches were modified using HMDSO plasma at different time treatments. Changes in functional properties of starch granule, film-forming solutions (FFS) and films were investigated. SEM analysis revealed HMDSO coating deposition on the granule surface, which limited the amylopectin leach out from the granules to the continuous matrix, affecting the rheological properties of the FFS. The amylopectin restriction resulted in a low reinforcement of the network decreasing the viscosity as indicated by n and k values. Also, a gel-like behavior (G' > Gâ³) was observed when the amylose and time treatment increased, suggesting that the matrix becomes less elastic with softer entanglement. This behavior was confirmed by creep test and Burger model parameters. The plasma treatments allowed obtaining FFS with low viscosity, suitable for developing soft and hydrophobic films with low flexibility, as indicated by the decrease of the maximum stress, Hencky strain and permeance values.
RESUMEN
In the last century, starch present in foods was considered to be completely digested. However, during the 1980s, studies on starch digestion started to show that besides digestible starch, which could be rapidly or slowly hydrolysed, there was a variable fraction that resisted hydrolysis by digestive enzymes. That fraction was named resistant starch (RS) and it encompasses those forms of starch that are not accessible to human digestive enzymes but can be fermented by the colonic microbiota, producing short-chain fatty acids. RS has been classified into five types, depending on the mechanism governing its resistance to enzymatic hydrolysis. Early research on RS was focused on the methods to determine its content in foods and its physiological effects, including fermentability in the large intestine. Later on, due to the interest of the food industry, methods to increase the RS content of isolated starches were developed. Nowadays, the influence of RS on the gut microbiota is a relevant research topic owing to its potential health-related benefits. This review summarizes over 30 years of investigation on starch digestibility, its relationship with human health, the methods to produce RS and its impact on the microbiome. © 2018 Society of Chemical Industry.
Asunto(s)
Almidón/metabolismo , Animales , Bacterias/metabolismo , Digestión , Fermentación , Microbioma Gastrointestinal , Humanos , Almidón Resistente/metabolismoRESUMEN
There is a growing interest in the development of functional ingredients, including those with high indigestible carbohydrate content. Unripe plantain flour (UPF) is a source of indigestible carbohydrates, type II resistant starch (RS) in particular. A major drawback of UPF, however, is that its RS content decreases sharply after wet heat treatment. Here, we explore the possibility of preparing an extruded UPF-based functional ingredient that retains limited starch digestibility features and high dietary fiber content. Both an unripe plantain pulp flour (UPFP) and a whole (pulp and peel) unripe plantain flour (UPFW) were prepared, extruded under identical conditions and evaluated for their gelatinization degree, total starch (TS), resistant starch (RS), and total dietary fiber (TDF) content; functional properties, such as pasting profile, water retention capacity, and solubility, and oil absorption index were also analyzed. The extruded functional ingredient was added to a yogurt and the rheological characteristics and in vitro starch digestibility of the product were evaluated. The extruded UPFW showed a lower gelatinization degree than the extruded UPFP, which may be due to the higher non-starch polysaccharide content of the former. A high TDF content was recorded in both extrudates (12.4% in UPFP and 18.5% in UPFW), including a significant RS fraction. The water retention capacity and solubility indices were higher in the extruded flours, particularly in UPFW, while only marginal differences in oil retention capacity were observed among the products. The addition of UPFP or UPFW (1.5 g TDF, w/v) to a yogurt did not alter the viscosity of the product, an important characteristic for the consumer's approval. Moreover, the composite yogurt showed a relatively low starch digestion rate. Extrusion of UPFs may be an alternative for the production of functional ingredients with important DF contents.
RESUMEN
The phenolic compounds, color and antioxidant capacity of gluten-free pasta prepared with non-conventional flours such as chickpea (CHF), unripe plantain (UPF), white maize (WMF) and blue maize (BMF) were analyzed. Fifteen phenolic compounds (five anthocyanins, five hydroxybenzoic acids, three hydroxycinnamic acids, one hydroxyphenylacetic acid and one flavonol) were identified in pasta prepared with blue maize, and 10 compounds were identified for samples prepared with white maize. The principal component analysis (PCA) led to results describing 98% of the total variance establishing a clear separation for each pasta. Both the proportion (25, 50 and 75%) and type of maize flour (white and blue) affected the color parameters (L*, C ab *, h ab and ΔE* ab ) and antioxidant properties (DPPH, ABTS and FRAP methods) of samples, thus producing gluten-free products with potential health benefits intended for general consumers (including the population with celiac disease).