RESUMEN
Na3V2(PO4)2F3 (NVPF), a typical sodium superionic conductor (NASICON) type structure, has attracted much interest as a potential positive electrode in sodium-ion battery. However, the inherently poor electronic conductivity of phosphates compromises the electrochemical properties of this material. Here, we develop a general strategy to improve the electrochemical performance by preparing a new composite material "polyaniline (PANI)@NVPF" using a Pickering emulsion method. The X-ray diffraction and Raman results indicated a successful PANI coating without affecting the NASICON-type structure of NVPF, and they enhanced the interfacial bonding between the two components. Also, thermogravimetric analysis and scanning electron microscopy analyses revealed that the PANI content influenced the thermal stability and morphology of the nanocomposites. As a result, the sodium test cells exhibited multielectron reactions and a better rate performance for PANI@NVPF nanocomposites as compared to NVPF. Specifically, 2%PANI@NVPF maintained 70% of its initial capacity at 5C. Ex-situ electron paramagnetic resonance revealed the existence of mixed valence states of vanadium (V4+/V3+) in both discharge and charge processes. Consequently, the successful PANI coating into the sodium superionic conductor framework improved the sodium diffusion channels with a measurable increase of diffusion coefficients with cycling (ca. 3.25 × 10-11 cm2 s-1). Therefore, PANI@NVPF nanocomposites are promising cathode candidates for high-rate sodium-ion battery applications.
RESUMEN
This paper reports the development of novel adsorbent materials using polyaniline (PANI) grafted onto Posidonia (POS) fibers, aimed at efficiently removing phenol red (PSP), an anionic dye, from aqueous solutions. The synthesis involved the copolymerization of aniline grafted on the surface of the POS and aniline monomer in solution, resulting in a chemically bound thin PANI layer on the POS bioadsorbent. Structural characteristics and binding affinities of these adsorbents with PANI under its emeraldine salt (POS@PANI-ES) or emeraldine base (POS@PANI-EB) forms are reported. The rapid adsorption kinetics observed are attributed to enhanced accessibility to PANI adsorption sites on the POS surface. The binding percentages of PSP to POS@PANI-ES and POS@PANI-EB materials were found to be 97 and 50%, respectively, after 15 min of contact time. The Langmuir model for localized adsorption sites and the Volmer model for nonlocalized adsorption as a mobile layer were fitted to the experimental adsorption isotherms of PSP to POS@PANI-EB and POS@PANI-ES, yielding the thermodynamic parameters of adsorption. The adsorption capacities of PSP on POS@PANI-EB and POS@PANI-ES were 37.8 and 71.5 µmol g-1, respectively. The adsorption of PSP remained above 80% at moderate salt concentrations of around 0.1 mol L-1; however, higher concentrations of NaCl and CaCl2 in PSP solutions significantly reduced the adsorption on POS@PANI-ES.
RESUMEN
The presence of antibiotics as micro-contaminants in the water and aqueous environments is a health concern to humans and the ecosystem. Therefore, their elimination by adsorption to available and cheap materials in water treatment plants is a research topic of high relevance. The present paper reports on the adsorption behavior of oxytetracycline on a bio-adsorbent prepared from Posidonia oceanica; an abundant Mediterranean biomass. Characterization of the pretreated Posidonia biomaterial was achieved using several analyses such as Boehm acid-base titration method, pHPZC determination, and analysis techniques (FTIR, 13C CP-MAS NMR, optical microscopy, and TGA). The pHPZC occurred around pH 2.11. Posidonia biomaterial showed a fast and high uptake rate throughout the adsorption process, which is a definite advantage for analytical applications such as water decontamination. The experimental kinetic data fitted very rightly the pseudo-second-order kinetic model and the equilibrium uptake can adopt the bi-Langmuir isotherm model for all studied pH values which assumes adsorptions at the two localized sites. Maximum adsorption capacities of 11.8 mgâg-1 and 4.4 mgâg-1 for the two adsorption sites are reached at pH 6. The oxytetracycline adsorption process onto Posidonia bio-adsorbent is spontaneous (ΔadsG0 < 0), exothermic (ΔadsH0 < 0), and entropically favorable (ΔadsS0 > 0). The effect of pH on adsorption behavior and the thermodynamic parameters of adsorption are consistent with a possible origin of adsorption of oxytetracycline by means of hydrogen bonding interactions between surface hydroxyl and phenolic groups of the biomaterial and oxytetracycline. The proposed green and environmentally friendly biomaterial offers potential benefits as a bio-adsorbent in the remediation of aquatic environments contaminated by various organic materials.