RESUMEN
Biodiesel is an eco-friendly renewable fuel that can be derived from microalgae. Maximization of biomass and lipid productivities are considered the main challenges for algal biodiesel production. Since conventional batch cultures are time-, space-, and reagent-consuming with many restrictions to apply many replicates, microfluidic technology has recently emerged as an alternative low-cost and efficient technology with high throughput repeatability and reproducibility. Different applications of microfluidic devices in algal biotechnology have been reported, including cell identification, sorting, trapping, and metabolic screening. In this work, Chlorella vulgaris was investigated by encapsulating in a simple droplet-based micro-array device at different light intensities of 20, 80, and 200 µmol/m2/s combined with different nitrate concentrations of 17.6, 8.8, and 4.4 mM. The growth results for C. vulgaris within microfluidic device were compared to the conventional batch culture method. In addition, the effect of combined stress of deficiencies in irradiance and nitrogen availability were studied to illustrate their impact on the metabolic profiling of microalgae. The results showed that the most optimum favorable culturing conditions for Chlorella vulgaris growth within the microfluidic channels were 17.6 mM and 80 µmol/m2/s.
Asunto(s)
Chlorella vulgaris/metabolismo , Dispositivos Laboratorio en un Chip , Biomasa , Biotecnología/métodos , Cinética , Nitratos/metabolismoRESUMEN
Nanopore-based technologies are highly adaptable supports for developing label-free sensor chips to characterize lipid bilayers, membrane proteins, and nucleotides. We utilized a single nanopore chip to study the electrophysiology of the epithelial Na+ channel (ENaC) incorporated in supported lipid membrane (SLM). An isolated nanopore was developed inside the silicon cavity followed by fusing large unilamellar vesicles (LUVs) of DPPS (1,2-dipalmitoyl-sn-glycero-3-phosphoserine) and DPPE (1,2-dipalmitoyl-sn-glycero-3-phosphoethanolamine) to produce a solvent-free SLM with giga-ohm (GΩ) sealed impedance. The presence and thickness of SLM on the nanopore chip were confirmed using atomic force spectroscopy. The functionality of SLM with and without ENaC was verified in terms of electrical impedance and capacitance by sweeping the frequency from 0.01 Hz to 100 kHz using electrochemical impedance spectroscopy. The nanopore chip exhibits long-term stability for the lipid bilayer before (144 h) and after (16 h) incorporation of ENaC. Amiloride, an inhibitor of ENaC, was utilized at different concentrations to test the integrity of fused ENaC in the lipid bilayer supported on a single nanopore chip. The developed model presents excellent electrical properties and improved mechanical stability of SLM, making this technology a reliable platform to study ion channel electrophysiology.
Asunto(s)
Nanoporos , Espectroscopía Dieléctrica , Canales Epiteliales de Sodio , Transporte Iónico , Membrana Dobles de LípidosRESUMEN
Supported lipid bilayers (SLBs) are widely used in biophysical research to probe the functionality of biological membranes and to provide diagnoses in high throughput drug screening. Formation of SLBs at below phase transition temperature (Tm) has applications in nano-medicine research where low temperature profiles are required. Herein, we report the successful production of SLBs at above-as well as below-the Tm of the lipids in an anisotropically etched, silicon-based micro-cavity. The Si-based cavity walls exhibit controlled temperature which assist in the quick and stable formation of lipid bilayer membranes. Fusion of large unilamellar vesicles was monitored in real time in an aqueous environment inside the Si cavity using atomic force microscopy (AFM), and the lateral organization of the lipid molecules was characterized until the formation of the SLBs. The stability of SLBs produced was also characterized by recording the electrical resistance and the capacitance using electrochemical impedance spectroscopy (EIS). Analysis was done in the frequency regime of 10-2-105 Hz at a signal voltage of 100 mV and giga-ohm sealed impedance was obtained continuously over four days. Finally, the cantilever tip in AFM was utilized to estimate the bilayer thickness and to calculate the rupture force at the interface of the tip and the SLB. We anticipate that a silicon-based, micron-sized cavity has the potential to produce highly-stable SLBs below their Tm. The membranes inside the Si cavity could last for several days and allow robust characterization using AFM or EIS. This could be an excellent platform for nanomedicine experiments that require low operating temperatures.
Asunto(s)
Membrana Celular/química , Membrana Dobles de Lípidos/química , Nanomedicina , Fosfatidilcolinas/aislamiento & purificación , Anisotropía , Biofisica , Espectroscopía Dieléctrica/métodos , Humanos , Membrana Dobles de Lípidos/aislamiento & purificación , Microscopía de Fuerza Atómica/métodos , Transición de Fase , Fosfatidilcolinas/química , Silicio/química , TemperaturaRESUMEN
Lipid membranes regulate the flow of nutrients and communication signaling between cells and protect the sub-cellular structures. Recent attempts to fabricate artificial systems using nanostructures that mimic the physiological properties of natural lipid bilayer membranes (LBM) fused with transmembrane proteins have helped demonstrate the importance of temperature, pH, ionic strength, adsorption behavior, conformational reorientation and surface density in cellular membranes which all affect the incorporation of proteins on solid surfaces. Much of this work is performed on artificial templates made of polymer sponges or porous materials based on alumina, mica, and porous silicon (PSi) surfaces. For example, porous silicon materials have high biocompatibility, biodegradability, and photoluminescence, which allow them to be used both as a support structure for lipid bilayers or a template to measure the electrochemical functionality of living cells grown over the surface as in vivo. The variety of these media, coupled with the complex physiological conditions present in living systems, warrant a summary and prospectus detailing which artificial systems provide the most promise for different biological conditions. This study summarizes the use of electrochemical impedance spectroscopy (EIS) data on artificial biological membranes that are closely matched with previously published biological systems using both black lipid membrane and patch clamp techniques.