RESUMEN
Correction for 'Porous oligomeric materials synthesised using a new, highly active precatalyst based on ruthenium(III) and 2-phenylpyridine' by Kacper Poblocki et al., Dalton Trans., 2024, 53, 4194-4203, https://doi.org/10.1039/D3DT04091G.
RESUMEN
There are few literature reports on using precatalysts based on ruthenium(II/III) ions in the polymerization of olefins. Therefore, a new coordination compound was designed based on ruthenium(III) ion and 2-phenylpyridine. The resulting monocrystal was characterized by X-ray diffraction (XRD), solid-state (photo)IR spectroscopy, scanning electron microscopy (SEM), and thermogravimetric analysis (TGA). The new ruthenium(III) complex compound was used as a precatalyst in the oligomerization reactions of ethylene, 2-propen-1-ol, 2-chloro-2-propen-1-ol, 3-butene-2-ol and 2,3-dibromo-2-propen-1-ol with methylaluminoxane and ethylaluminium dichloride as activators. The catalytic activity of the newly discovered ruthenium(III) complex compound ranges from 159.5 (for 2-chloro-2-propen-1-ol) to 755.6 (for ethylene) g mmol-1 h-1 bar-1, indicating that it is a chemical compound with high catalytic activity. In addition, the oligomerization reaction products were subjected to physicochemical characterization, using BET (Brunauer-Emmett-Teller isotherm), mass spectrometry (MALDI-TOF-MS), Fourier transform infrared (FT-IR) spectroscopy, NMR, TGA, differential scanning calorimetry (DSC), and the morphology of the porous polymeric materials was investigated by SEM. The distinguishing feature of the obtained precatalyst is its high catalytic activity under mild reaction conditions, a rare phenomenon. Compared with other precatalysts, it is the most active ruthenium(II/III) ion-based catalytic material used in oligo- and polymerization reactions of ethylene.
RESUMEN
An efficient nitrite nickel(II) photoswitch, with the 1-phenyl-2-hydroxyimino-3-[(2'-dimethylamino)ethyl]imino-1-propanone moiety used as the ancillary ligand, is reported. In the ground-state ('dark') crystal structure, the studied compound exists predominantly as the nitro-(η1 -N(O)2 ) isomer, however, traces of the exo- and endo-nitrito-(η1 -ONO) forms are detected both at 100â K (4-5 % each) and under ambient conditions (~9 % each). When excited with the 405-530â nm LED light, the nitro-to-nitrito isomerization takes place. The total conversion exceeds 90 %. The exo-nitrito linkage isomer constitutes the dominant photo-generated form, whereas the relative population of both nitrito species depends on temperature. The reaction is fully reversible and reproducible. The photo-products are stable up to 200â K. The system constitutes a good model case for the reaction mechanism studies. Thus, experimental and theoretical investigations on the photo-isomerism were conducted and are presented in detail. Eventually, the nitroâexo-nitritoâendo-nitrito reaction pathway is proposed.
RESUMEN
Correction for 'An optically reversible room-temperature solid-state cobalt(III) photoswitch based on nitro-to-nitrito linkage isomerism' by Krystyna A. Deresz et al., Chem. Commun., 2022, 58, 13439-13442, https://doi.org/10.1039/d2cc05134f.
RESUMEN
A simple trinitro cobalt complex [Co(3,3'-diamino-N-methylpropanediamine)(NO2)3] was proven to be photoswitchable at room temperature as the Pca21 polymorph with the maximum nitro-to-nitrito conversion reaching ca. 55%. Solid-state IR, UV-vis and XRD indicate that the transformation can be triggered optically in both ways via 470 nm and 570-660 nm LED light, respectively.