RESUMEN
Transition metal catalysts in soil constituents (e.g., clays) can significantly decrease the pyrolytic treatment temperature and energy requirements for efficient removal of polycyclic aromatic hydrocarbons (PAHs) and, thus, lead to more sustainable remediation of contaminated soils. However, the catalytic mechanism and its rate-limiting steps are not fully understood. Here, we show that PAHs with lower ionization potential (IP) are more easily removed by pyro-catalytic treatment when deposited onto Fe-enriched bentonite (1.8% wt. ion-exchanged content). We used four PAHs with decreasing IP: naphthalene > pyrene > benz(a)anthracene > benzo(g,h,i)perylene. Density functional theory (DFT) calculations showed that lower IP results in stronger PAH adsorption to Fe(III) sites and easier transfer of π-bond electrons from the aromatic ring to Fe(III) at the onset of pyrolysis. We postulate that the formation of aromatic radicals via this direct electron transfer (DET) mechanism is the initiation step of a cascade of aromatic polymerization reactions that eventually convert PAHs to a non-toxic and fertility-preserving char, as we demonstrated earlier. However, IP is inversely correlated with PAH hydrophobicity (logâ¯Kow), which may limit access to the Fe(III) catalytic sites (and thus DET) if it increases PAH sorption to soil OM. Thus, ensuring adequate contact between sorbed PAHs and the catalytic reaction centers represents an engineering challenge to achieve faster remediation with a lower carbon footprint via pyro-catalytic treatment.
RESUMEN
Transition metal catalysts can significantly enhance the pyrolytic remediation of soils contaminated with polycyclic aromatic hydrocarbons (PAHs). Significantly higher pyrene removal efficiency was observed after the pyrolytic treatment of Fe-enriched bentonite (1.8% wt ion-exchanged content) relative to natural bentonite or soil (i.e., 93% vs 48% and 4%) at the unprecedentedly low temperature of 150 °C with only 15 min treatment time. DFT calculations showed that bentonite surfaces with Fe3+ or Cu2+ adsorb pyrene stronger than surfaces with Zn2+ or Na+. Enhanced pyrene adsorption results from increased charge transfer from its aromatic π-bonds to the cation site, which destabilizes pyrene allowing for faster degradation at lower temperatures. UV-Vis and GC-MS analyses revealed pyrene decomposition products in extracts of samples treated at 150 °C, including small aromatic compounds. As the pyrolysis temperature increased above 200 °C, product distribution shifted from extractable compounds to char coating the residue particles. No extractable byproducts were detected after treatment at 400 °C, indicating that char was the final product of pyrene decomposition. Tests with human lung cells showed that extracts of samples pyrolyzed at 150 °C were toxic; thus, high removal efficiency by pyrolytic treatment does not guarantee detoxification. No cytotoxicity was observed for extracts from Fe-bentonite samples treated at 300 °C, inferring that char is an appropriate treatment end point. Overall, we demonstrate that transition metals in clay can catalyze pyrolytic reactions at relatively low temperatures to decrease the energy and contact times required to meet cleanup standards. However, mitigating residual toxicity may require higher pyrolysis temperatures.
Asunto(s)
Bentonita , Hidrocarburos Policíclicos Aromáticos , Humanos , Temperatura , Bentonita/química , Pirólisis , Pirenos/química , SueloRESUMEN
Pyrolytic treatment of crude-oil contaminated soils offers great potential for rapid remediation without destroying soil fertility with lower energy requirements than incineration. Here, we show that clays impregnated with non-toxic transition metals (iron or copper) can be used as an amendment to decrease the required pyrolytic treatment temperature and time. Amending a weathered crude-oil contaminated soil with 10 % (by weight) of bentonite modified via ion-exchange with Fe or Cu, achieved 99 % removal of residual total petroleum hydrocarbons (TPH) at a pyrolysis temperature of 370 °C with 15-min contact time. Pyrolytic treatment of amended soils at the unprecedentedly low pyrolysis temperature of 300 °C resulted in 87 % TPH removal efficiency with Cu-bentonite and a 93 % with Fe-bentonite. We postulate that the transition metals catalyzed the pyrolysis reactions at lower onset temperatures. This hypothesis is supported by thermogravimetric analysis coupled with mass spectrometry, which revealed the release of hydrogen, methyl and propyl ion fragments (markers of pyrolytic degradation products of crude oil) at lower temperatures than those observed for unamended soil. Overall, this work shows proof of concept that metal-impregnated clays can enhance rapid pyro-catalytic treatment of crude-oil contaminated soils and encourages further work to understand the detailed reaction mechanisms and inform process design.