RESUMEN
This research aimed to produce eco-friendly straws using soy protein isolate (SPI) and cassava starch (CS) at different ratios by the extrusion technique and by coating with beeswax and shellac wax. Three straw formulations (F) (F1: 24.39% SPI-24.39% CS; F2: 19.51% SPI-29.37% CS; and F3: 14.63% SPI-34.15% CS) were prepared, incorporating glycerol (14.6% w/w) and water (36.6% w/w). After extrusion and drying at 80 °C for 20 h, visual assessment favored F2 straws due to smoother surfaces, the absence of particles, and enhanced straightness. For the physical property test, the straws were softened in pH buffer solutions for 5 min. To simulate practical application, mechanical bending strength was studied under different relative humidity (RH) settings. Water absorption reduced the strength as RH increased. F2 straws outperformed other formulations in bending strength at 54% RH. For hydrophobic coatings, F2 was chosen. Beeswax- and shellac wax-coated straws displayed negligible water absorption and sustained their integrity for over 6 h compared to uncoated straws. This study shows that extrusion and natural coatings may make sustainable straws from SPI and CS. These efforts help meet the growing demand for eco-friendly plastic alternatives, opening up new options for single-use straws.
RESUMEN
This study aimed to investigate the preparation of soy protein isolated (SPI) cutlery incorporated with 5-20% (w/w) crude morning glory stem fiber (MGSF). SPI cutlery samples without and with MGSF were subjected to hydraulic hot press molding at 160 °C for 5 min pressing time. SPI with 5% MGSF showed decreased lightness values compared to the control SPI (without MGSF) (p < 0.05). Flexural modulus attained in SPI with 5% MGSF was higher and subsequently showed decreases in impact strength and compression load compared to the control SPI (p < 0.05). SPI with 5% MGSF sample showed slightly lower water absorption followed by decreases in degree of swelling and solubility with that of the control SPI (p < 0.05). Micrographs revealed a 5% MGSF formed uniform matrix with SPI in comparison to the control and other treatments that showed cracks with the increased fiber addition. Additionally, stiffness decreased with the addition of 5% MGSF to SPI thereby increasing deflection in comparison to the control SPI and other treatments. Thus, SPI cutlery added with 5% MGSF potentially retained the physical and mechanical properties of edible and biodegradable cutlery for food applications.