RESUMEN
The healthcare-associated infections (HAIs) and pandemics caused by multidrug-resistant (MDR) and new-generation pathogens threaten the whole world community. Cu and its alloys have been attracting widespread interest as anti-contamination materials due to the rapid inactivation of MDR-superbugs and viruses. Applying thin Cu-based foils on pre-existing surfaces in hygiene-sensitive areas represents a quick, simple, cost-effective self-sanitising practice. However, the influence of chemical composition and microstructure should be deeply investigated when evaluating the antimicrobial capability and durability of Cu-based materials. The effect of composition on micromechanical and antiviral properties was investigated by comparing Cu15Zn and Cu18Ni20Zn (foil thickness from 13 to 27 µm) with Phosphorous High-Conductivity (PHC) Cu. The influence of recrystallisation annealing of PHC Cu was also investigated. Microstructural characterisation was carried out by optical (OM) and scanning electron (FEG-SEM) microscopy, Energy-dispersive Spectroscopy (EDS) and Electron-Backscattered Diffraction (EBSD). The micromechanical behaviour was assessed by microhardness, microscale abrasion and scratch tests. Cu-based foils were exposed to SARS-CoV-2 for different time points in quasi-dry conditions (artificial sweat solution), evaluating their antiviral capability by quantitative Reverse-Transcriptase Polymerase Chain Reaction (qRT-PCR). Surface morphology, contact angle measurements and Cu release were measured. All Cu-based surfaces completely inactivated SARS-CoV-2 in 10 min: pure Cu was the best option regarding antiviral efficiency, while Cu15Zn showed the best trade-off between micromechanical and antiviral properties.
RESUMEN
AIMS: Enumeration of resistant bacteria in ultra-high temperature (UHT) treated milk; morphological characterization and phenotyping of resistant strains by traditional and nontraditional methods and their identification by molecular biology. METHODS AND RESULTS: Modified standard plate count agar (PCA) and modified brain-heart infusion (BHI) agar were used for colony counts. Physiological culture traits were determined as suggested by Bergey's Manual of Systematic Bacteriology or in modified J-broth or in modified BHI agar. Scanning electron microscope (SEM) was used for microscopic examination. Strain identification was carried out by polymerase chain reaction (PCR). A total of 125 (62.81% of 199) samples were positive and the bacterial load was higher than 10(5) CFU ml(-1) in 46 samples (28.80% of 125). The 16S rRNA sequence of bacterial cultures obtained from UHT-treated milk was similar to that of Bacillus sporothermodurans M215 type strain((T)) and different biotypes were found by analysis of colony appearance, cell morphology and physiological traits. CONCLUSIONS: Bacillus sporothermodurans was the predominant sporigenous micro-organisms in UHT milk. SIGNIFICANCE AND IMPACT OF THE STUDY: BHI agar is more suitable than PCA for quality control of milk after UHT treatment. Modified J-broth medium is useful to determine selected physiological traits of B. sporothermodurans. The strains characterized and identified as B. sporothermodurans were significantly different compared with the type strain.