RESUMEN

In this study, biomass of rice straw (RS) and wood (WD) and their torrefied biomass (RST and WDT) were used as solid biofuel (SBF) for co-firing individually with coal in a commercial continuous chain-grate steam boiler system, which was conducted at fixed input rate of heating value of mixture of SBF and coal and at fixed airflow rate. The effects of key system parameters on the gaseous and particulate pollutions and ash were examined. These include SBF type and blending ratio (RBL) of biomass (i.e., SBF) in the mixture of coal and biomass based on heating values for co-firing.The results indicated that wood, which possesses high heating value while less amount of ash, is more suitable for co-firing with coal than rice straw. Torrefaction can increase the heating value of biomass and homogenize its property, being beneficial to co-firing. Also, torrefaction can decompose the hydroxyl group of biomass, which makes biomass tending to possess hydrophobicity. This, in turn, helps the storage and transportation of biomass. Generally, adding the RS (with RBL = 5-10%), WD (2-15%), RST (2-10%) and WDT (2-20%), respectively, with coal decreases the emissions of NOx and SO2, but increases that of CO (except RST). The emission of HCl is little. The addition of biomass also increases the emission of fine particulate matters (PM) especially PM2.5 in the flue gases, raising PM2.5/PM100 from 34.87 to 78.35 wt.% (Case 50%WDT). These emissions for the Cases tested satisfy with Taiwanese emission standards of stationary sources which set limitations of NOx, SO2, CO and HCl < 350, 300, 2000 and 80 ppmv, while PM < 50 mg/m3, respectively. The results support the use of RS, WD, RST and WDT for co-firing with coal.Implications: This study examined the suitability of using solid bio-fuels to co-fire with coal in an industrial chain-grate steam boiler system with a capacity of 100 kW, in order to achieve carbon-free emissions. Both biomass and torrefied biomass of solid bio-fuel were tested. The findings would be useful for proper design and rational operation of solid bio-fuel/coal co-firing combustion matching the appeal of sustainable material management and circular economy of biomass, and of adaptation of global warming induced by greenhouse gases. It also provides information for policy-makers to promote the co-firing application of biomass and related bio-waste materials.

Asunto(s)

RESUMEN

<p><b>Background</b>Percutaneous transluminal septal myocardial ablation (PTSMA) and modified Morrow septal myectomy (MMSM) are two invasive strategies used to relieve obstruction in patients with hypertrophic cardiomyopathy (HCM). This study aimed to determine the clinical outcome of these two strategies.</p><p><b>Methods</b>From January 2011 to January 2015, 226 patients with HCM were treated, 68 by PTSMA and 158 by MMSM. Both ultrasonic cardiograms and heart functional class were recorded before, after operations and in the follow-up. Categorical variables were compared using Chi-square or Fisher's exact tests. Quantitative variables were compared using the paired samples t-test.</p><p><b>Results</b>Interventricular septal thickness was significantly reduced in both groups (21.27 ± 4.43 mm vs. 18.72 ± 4.13 mm for PTSMA, t = 3.469, P < 0.001, and 21.83 ± 5.03 mm vs. 16.57 ± 3.95 mm for MMSM, t = 10.349, P < 0.001, respectively). The left ventricular outflow tract (LVOT) pressure gradient (PG) significantly decreased after the operations in two groups (70.30 ± 44.79 mmHg vs. 39.78 ± 22.07 mmHg for PTSMA, t = 5.041, P < 0.001, and 74.58 ± 45.52 mmHg vs. 13.95 ± 9.94 mmHg for MMSM, t = 16.357, P < 0.001, respectively). Seven patients (10.29%) in the PTSMA group required a repeat operation in the follow-up. Eight (11.76%) patients were evaluated for New York Heart Association (NYHA) III/IV in the PTSMA group, which was significantly more than the five (3.16%) in the same NYHA classes for the MMSM group at follow-up. Less than 15% of patients in the PTSMA group and none of the patients in the MMSM group complained of chest pain during follow-up.</p><p><b>Conclusions</b>Both strategies can not only relieve LVOT PG but also improve heart function in patients with HCM. However, MMSM might provide a more reliable reduction in gradients compared to PTSMA.</p>

RESUMEN

The chemical and physical gradients in the native cell microenvironment induce intracellular polarization and control cell behaviors such as morphology, migration and phenotypic changes. Directed cell migration in response to substrate stiffness gradients, known as durotaxis or mechanotaxis, has drawn attention due to its significance in development, metastasis, and wound healing. We developed a microcomposite substrate (µCS) platform with a microfabricated base and collagen hydrogel top to generate physiological linear stiffness gradients without any variation in chemical or transport properties. This platform is compatible with both 2D and 3D cell culturing and can be assembled with common supplies found in most biology labs. Ligament fibroblasts (LFs) and mesenchymal stem cells (MSCs) both respond to the mechanical gradient with directed migration. Interestingly, LFs exhibit higher mechanosensitivity compared with MSCs. Polarized nonmuscle myosin IIB distribution was also found on the µCS gradient, confirming previous reports. This robust system provides an easily accessible platform to study cell mechanosensing and a more physiological microenvironment for cell studies.

Asunto(s)