RESUMEN
Catalytic co-pyrolysis of two different refinery oily sludge (ROS) samples was conducted to facilitate resource recovery. Non-catalytic pyrolysis in temperatures ranging from 500 to 600°C was performed to determine high oil yields. Higher temperatures enhanced the oil yields up to ~ 24 wt%, while char formation remained unchanged (~ 45%) for S1. Conversely, S2 exhibited a notably lower oil yield (~ 4 wt%) than S1. Pyrolysis oil of S1 consisted of phenolics (~ 50% at 600 °C) whereas hydrocarbons were predominant in S2 oil (~ 80% at 600 °C). Catalytic pyrolysis of S1 did not exhibit a substantial impact on oil yields but the oil composition varied significantly. High hydrocarbons, phenolics, and aromatics were obtained with molecular sieve (MS), metal slag, and ZSM-5, respectively. Catalytic co-pyrolysis of S2 with sawdust (SD) in the presence of MS enhanced the oil yield, and the resulting oil consisted of high hydrocarbons (~ 54%) and aromatics (~ 44%).
Asunto(s)
Biomasa , Pirólisis , Aguas del Alcantarillado , Catálisis , Aguas del Alcantarillado/química , Petróleo , Hidrocarburos/químicaRESUMEN
Bismuth-doped metal oxides exhibit favourable photocatalytic features when exposed to both sunlight and UV light. In this approach, Bi0/TiO2 and Bi+3/TiO2 photocatalysts were prepared and their structural and optical properties are analysed using various characterization techniques. These developed photocatalysts were further tested for the photocatalytic elimination of Nitrobenzene in UV light and sunlight and compared with the performance of bare TiO2. The catalyst Bi+3/TiO2 performed better in UV light with 72.31% degradation, and 4.74 × 10-6 mol.litre-1.min-1 initial rate of reaction. However, when exposed to sunlight, Bi0/TiO2 outperformed with 73.85% degradation, and 4.63 × 10-6 mol.min-1 initial rate of reaction. This significant increase in photocatalytic activity of Bi0/TiO2 under sunlight could be accredited to increased light harvesting and enhanced efficiency in charge carrier separation, both of which were made possible by bismuth-induced surface plasmon resonance.
RESUMEN
This study investigates the utilization of carbon dots (CDs) from neem leaves (Azadirachta indica) decorated onto cadmium sulfide (CdS) for the photocatalytic degradation of ciprofloxacin. A comparative study of ciprofloxacin degradation with pristine CdS and CD decorated CdS demonstrated high degradation of â¼ 75 % with CD/CdS when compared to bare CdS (â¼68 %). Process optimization studies were further carried out with CD/CdS catalysts at different solution pH (4-10), feed concentrations (10-50 mg/L), catalyst loadings (25-125 mg/L), temperatures (10 - 30 °C), and lamp power (25, 50, 250 W and sunlight). Higher temperatures, combined with a solution pH of 7 and catalyst loading of 100 mg/L favored the enhanced degradation of 20 mg/L of ciprofloxacin. The ciprofloxacin degradation rate increased linearly with temperature with an apparent activation energy of 27 kJ mol-1. The CD/CdS photocatalyst demonstrated maximum degradation rates with higher lamp powers while it also showed remarkable performance under natural sunlight achieving the same degradation within 3 h.