RESUMEN
This study aimed to evaluate whether aluminum chloride (AlCl3) causes hematological changes in the peripheral blood of Sprague-Dawley (SD) rats. Five groups of female SD rats were intragastrically administered with 4 different concentrations of AlCl3 for 5 days a week for a total of 90 days. The aluminum concentration was determined via graphite furnace atomic absorption spectroscopy. Analysis of serum iron-kinetic profiles, blood cytometry outcomes, and blood smears of the blood samples. Scanning electron microscopy (SEM) and Raman spectroscopy were used to search for structural and ultrastructural changes, respectively. Blood aluminum concentration ranged 12.38-16.24 µg/L with no significant difference between experimental treatments. At the AlCl3 concentration of 40 mg Al/kg bw of rats/day, the mean ferritin value in the serum iron kinetic profile was 29.81±6.1 ng/mL, and this value showed a significant difference between experimental treatments. Blood cytometry revealed that there were 6.45-7.11×106 cells/µL erythrocytes, 8.91-9.32×103 cells/µL leukocytes, and 477.2-736.3×103 cells/µL platelets along with a hemoglobin of 37.38-41.93 g/dL and hematocrit level of 37.38-41.93%; the experimental treatments showed no significant differences. Erythrocyte structural analysis using SEM showed no differences between experimental treatments, whereas ultrastructural evaluation using Raman spectroscopy made it possible to identify the following bands: 741, 1123, 1350, 1578, and 1618 cm-1, which were respectively associated with the following vibrational modes and compounds: vibration of the tryptophan ring, asymmetric C-O-C stretching of glucose, C-H curve of tryptophan, C=C stretching of the heme group, and C-N stretching of the heme group, with no significant differences between experimental treatments. Therefore, AlCl3 administration does not induce ultrastructural changes in the erythrocyte membrane. This study revealed that serum ferritin concentration was the only parameter affected by AlCl3 exposure at 40 mg of Al/kg bw of rats/day.
RESUMEN
In this work, a capacitive sensor made of recycled material is proposed to monitor oil quality in automotive workshops in order to reduce the waste of useful lubricant oil caused by shorter periods of use than those established by the manufacturers. The sensor was fabricated from a recycled aluminum heat sink and used to measure the permittivity of oil samples. The proposed method was compared with Fourier-transform infrared spectroscopy analysis to evaluate degradation parameters, as described in standard practice ASTM E-2412. The obtained results showed good agreement between both techniques, validating the use of the proposed sensor to evaluate oil condition. The use of permittivity measurements could be used to evaluate oil quality in an easier, faster, and economical way compared with other laboratory tests.