RESUMEN
Cobalt oxides and (oxy)hydroxides have been widely studied as electrocatalysts for the oxygen evolution reaction (OER). For related Ni-based materials, the addition of Fe dramatically enhances OER activity. The role of Fe in Co-based materials is not well-documented. We show that the intrinsic OER activity of Co(1-x)Fe(x)(OOH) is â¼100-fold higher for x ≈ 0.6-0.7 than for x = 0 on a per-metal turnover frequency basis. Fe-free CoOOH absorbs Fe from electrolyte impurities if the electrolyte is not rigorously purified. Fe incorporation and increased activity correlate with an anodic shift in the nominally Co(2+/3+) redox wave, indicating strong electronic interactions between the two elements and likely substitutional doping of Fe for Co. In situ electrical measurements show that Co(1-x)Fe(x)(OOH) is conductive under OER conditions (â¼0.7-4 mS cm(-1) at â¼300 mV overpotential), but that FeOOH is an insulator with measurable conductivity (2.2 × 10(-2) mS cm(-1)) only at high overpotentials >400 mV. The apparent OER activity of FeOOH is thus limited by low conductivity. Microbalance measurements show that films with x ≥ 0.54 (i.e., Fe-rich) dissolve in 1 M KOH electrolyte under OER conditions. For x < 0.54, the films appear chemically stable, but the OER activity decreases by 16-62% over 2 h, likely due to conversion into denser, oxide-like phases. We thus hypothesize that Fe is the most-active site in the catalyst, while CoOOH primarily provides a conductive, high-surface area, chemically stabilizing host. These results are important as Fe-containing Co- and Ni-(oxy)hydroxides are the fastest OER catalysts known.
RESUMEN
Ni-borate materials are oxygen evolution catalysts that operate at near-neutral pH and have been found previously to improve due to structural changes induced via anodic conditioning. We find that this increased activity after conditioning at 0.856 V vs. SCE, as measured on a turn-over frequency basis (TOF) at 400 mV overpotential (TOF = 0.38 s(-1)), accompanies significant Fe incorporation (14%). Films conditioned in Fe-free electrolyte exhibit â¼10 times lower activity (TOF = 0.03 s(-1)). By co-depositing Fe-Ni we demonstrate high activity without conditioning (TOF = 0.24 s(-1)) which improves further with shortened (â¼30 min) conditioning (TOF = 1.4 s(-1)).
RESUMEN
First-row transition-metal oxides and (oxy)hydroxides catalyze the oxygen evolution reaction (OER) in alkaline media. Understanding the intrinsic catalytic activity provides insight into improved catalyst design. Experimental and computationally predicted activity trends, however, have varied substantially. Here we describe a new OER activity trend for nominally oxyhydroxide thin films of Ni(Fe)O(x)H(y) > Co(Fe)O(x)H(y) > FeO(x)H(y)-AuO(x) > FeO(x)H(y) > CoO(x)H(y) > NiO(x)H(y) > MnO(x)H(y). This intrinsic trend has been previously obscured by electrolyte impurities, potential-dependent electrical conductivity, and difficulty in correcting for surface-area or mass-loading differences. A quartz-crystal microbalance was used to monitor mass in situ and X-ray photoelectron spectroscopy to measure composition and impurity levels. These new results provide a basis for comparison to theory and help guide the design of improved catalyst systems.