RESUMEN
Anilines are ubiquitous in bio-active compounds and their synthesis can be achieved via metal-catalyzed cross-coupling reactions involving aryl halides. We describe an unusual, yet simple, CuII-catalyzed system for the amination of aryl chlorides in pure aqueous ammonia with 2.5 mol% catalyst loading under non-inert conditions. Different from previous systems, the reaction proceeds even without an additional organic solvent. Copper(II) sulfate in combination with 4,7-dimethoxy-1,10-phenanthroline enabled the amination of several aryl chlorides containing electron-neutral, -donating and -withdrawing groups to the corresponding anilines with good to excellent yields. The upscaling potential of the procedure has been shown by the synthesis at 50 mmol scale. The reaction proceeds as one of the rare cases of a CuII-assisted coupling, in contrast to the typical CuI-CuIII intermediates postulated for most Ullmann-type coupling reactions. The copper(II) center allows for a nucleophilic substitution pathway, enabled by the deprotonation of coordinated ammonia.
RESUMEN
The conversion of aryl halides to primary arylamines with a convenient and inexpensive source of ammonia has been a long-standing synthetic challenge. Aqueous ammonia would be the most convenient and least expensive form of ammonia, but such a palladium-catalyzed amination reaction with a high concentration of water faces challenges concerning catalyst stability and competing hydroxylation, and palladium-catalyzed reactions with this practical reagent are rare. Further, most reactions with ammonia to form primary amines are conducted with tert-butoxide base, but reactions with ammonium hydroxide would contain hydroxide as base. Thus, ammonia surrogates, ammonia in organic solvents, and ammonium salts have been used under anhydrous conditions instead with varying levels of selectivity for the primary amine. We report the palladium-catalyzed amination of aryl and heteroaryl chlorides and bromides with aqueous ammonia and a hydroxide base to form the primary arylamine with high selectivity. The palladium catalyst containing a new dialkyl biheteroaryl phosphine ligand (KPhos) suppresses both the formation of aryl alcohol and diarylamine side products. Mechanistic studies with a soluble hydroxide base revealed turnover-limiting reductive elimination of the arylamine and an equilibrium between arylpalladium amido and hydroxo complexes prior to the turnover-limiting step.
RESUMEN
Reported here is the Pd-catalyzed C-N coupling of hydrazine with (hetero)aryl chlorides and bromides to form aryl hydrazines with catalyst loadings as low as 100â ppm of Pd and KOH as base. Mechanistic studies revealed two catalyst resting states: an arylpalladium(II) hydroxide and arylpalladium(II) chloride. These compounds are present in two interconnected catalytic cycles and react with hydrazine and base or hydrazine alone to give the product. The selectivity of the hydroxide complex with hydrazine to form aryl over diaryl hydrazine was lower than that of the chloride complex, as well as the catalytic reaction. In contrast, the selectivity of the chloride complex closely matched that of the catalytic reaction, indicating that the aryl hydrazine is derived from this complex. Kinetic studies showed that the coupling process occurs by rate-limiting deprotonation of a hydrazine-bound arylpalladium(II) chloride complex to give an arylpalladium(II) hydrazido complex.