RESUMEN
BACKGROUND: Articular cartilage undergoes age-associated degeneration, resulting in both structural and functional biomechanical changes. At early stages of degeneration, wear-lines develop in the general direction of joint movement. With aging, cartilage exhibits a decrease in tensile modulus. The tensile modulus of cartilage has also been related to the orientation of the collagen network, as revealed by split-lines. OBJECTIVE: To determine the relative contribution of wear-line and split-line orientation on the tensile biomechanical properties of human patellar cartilage from different depths. METHODS: In human patellar cartilage, wear- and split-lines are aligned parallel to each other at the proximal facet, and perpendicular to each other at the medial facet. Using superficial, middle, and deep cartilage sections from these two sites, tensile samples were prepared in two orthogonal orientations. Thus, for each depth, there were four groups of samples, with their long axes were aligned either parallel or perpendicular to wear-line direction and also aligned parallel or perpendicular to split-line direction. Uniaxial tensile tests were performed to assess equilibrium and ramp moduli. RESULTS: Tensile equilibrium moduli varied with wear-line orientation (P<0.05) and depth (P<0.001), in an interactive manner (P<0.05), and tended to vary with split-line orientation (P=0.16). In the superficial layer, equilibrium and ramp modulus were higher when the samples were loaded parallel to wear-lines (P<0.05). CONCLUSION: These results indicate that mild wear (i.e., wear-line formation) at the articular surface has deleterious functional effects on articular cartilage and represent an early aging-associated degenerative change. The identification and recognition of functional biomechanical consequences of wear-lines are useful for planning and interpreting tensile biomechanical tests in human articular cartilage.
Asunto(s)
Cartílago Articular/fisiología , Rótula/fisiología , Adulto , Envejecimiento/patología , Envejecimiento/fisiología , Fenómenos Biomecánicos , Carbono , Cartílago Articular/anatomía & histología , Humanos , Rótula/anatomía & histología , Coloración y Etiquetado/métodos , Resistencia a la TracciónRESUMEN
The synovial fluid (SF) of joints normally functions as a biological lubricant, providing low-friction and low-wear properties to articulating cartilage surfaces through the putative contributions of proteoglycan 4 (PRG4), hyaluronic acid (HA), and surface active phospholipids (SAPL). These lubricants are secreted by chondrocytes in articular cartilage and synoviocytes in synovium, and concentrated in the synovial space by the semi-permeable synovial lining. A deficiency in this lubricating system may contribute to the erosion of articulating cartilage surfaces in conditions of arthritis. A quantitative intercompartmental model was developed to predict in vivo SF lubricant concentration in the human knee joint. The model consists of a SF compartment that (a) is lined by cells of appropriate types, (b) is bound by a semi-permeable membrane, and (c) contains factors that regulate lubricant secretion. Lubricant concentration was predicted with different chemical regulators of chondrocyte and synoviocyte secretion, and also with therapeutic interventions of joint lavage and HA injection. The model predicted steady-state lubricant concentrations that were within physiologically observed ranges, and which were markedly altered with chemical regulation. The model also predicted that when starting from a zero lubricant concentration after joint lavage, PRG4 reaches steady-state concentration approximately 10-40 times faster than HA. Additionally, analysis of the clearance rate of HA after therapeutic injection into SF predicted that the majority of HA leaves the joint after approximately 1-2 days. This quantitative intercompartmental model allows integration of biophysical processes to identify both environmental factors and clinical therapies that affect SF lubricant composition in whole joints.