RESUMEN
The material flow analysis method can be used to assess the impact of environmental sanitation systems on resource consumption and environmental pollution. However, given the limited access to reliable data, application of this data-intensive method in developing countries may be difficult. This paper presents an approach allowing to develop material flow models despite limited data availability. Application of an iterative procedure is of key importance: model parameter values should first be assessed on the basis of a literature review and by eliciting expert judgement. If model outputs are not plausible, sensitive input parameters should be reassessed more accurately. Moreover, model parameters can be expressed as probability distributions and variable uncertainty estimated by using Monte Carlo simulation. The impact of environmental sanitation systems on the phosphorus load discharged into surface water in Hanoi, Vietnam, is simulated by applying the proposed approach.
Asunto(s)
Conservación de los Recursos Naturales , Contaminación Ambiental , Ingeniería Sanitaria , Países en Desarrollo , Modelos Teóricos , Sensibilidad y Especificidad , Incertidumbre , VietnamRESUMEN
Many areas in the world face clean water scarcity problems and phosphorus reserves are likely to be depleted in the near future. Still, a large amount of clean water is used to transport excreta through sewer systems. Most of the wastewater generated worldwide is discharged untreated into aquatic systems and leads to water pollution and loss of valuable nutrients. In Hanoi, Vietnam's capital city, high population and economic growth as well as industrialisation have led to a decrease in groundwater level and to serious river and lake pollution. A probabilistic model, simulating the impact of measures on groundwater abstraction and nutrient recovery, was used to determine the impact of policy changes in Hanoi. The results obtained reveal that harmonising environmental sanitation and agricultural systems with one another will considerably increase nutrient recovery for food production, lower expenditure for artificial fertilisers and reduce the nutrient load into the environment. The model can be applied in urban areas of developing countries to assist in the design of environmental sanitation concepts.
Asunto(s)
Agua Dulce/química , Fósforo/química , Ingeniería Sanitaria/métodos , Modelos Teóricos , Ingeniería Sanitaria/legislación & jurisprudencia , Urbanización , Vietnam , Contaminantes Químicos del Agua , Purificación del Agua/legislación & jurisprudencia , Purificación del Agua/métodosRESUMEN
Simple models based on the physical and biochemical processes occurring in septic tanks, pit and urine diversion latrines were developed to determine the nutrient flows in these systems. Nitrogen and phosphorus separation in different output materials from these on-site sanitation installations were thus determined. Moreover, nutrient separation in septic tanks was also assessed through literature values and by eliciting expert judgement. Use of formal expert elicitation technique proved to be effective, particularly in the context of developing countries where data is often scarce but expert judgement readily available. In Vietnam, only 5-14% and 11-27% of the nitrogen and phosphorus input, respectively, are removed from septic tanks with the faecal sludge. The remaining fraction leaves the tank via the liquid effluent. Unlike septic tanks, urine diversion latrines allow to immobilize most of the nutrients either in form of stored urine or dehydrated faecal matter. These latrines thus contribute to reducing the nutrient load in the environment and lowering consumption of energy and non-renewable resources for fertiliser production.
Asunto(s)
Países en Desarrollo , Modelos Teóricos , Aguas del Alcantarillado , Cuartos de Baño , Eliminación de Residuos Líquidos , Nitrógeno/análisis , Fósforo/análisis , Ingeniería Sanitaria/métodos , Saneamiento , VietnamRESUMEN
The temperature, redox conditions, and residence times of the solid waste on the grate and of the raw gas in the secondary combustion zone determine the mineralization processes of organics in municipal solid waste incinerators. An improved knowledge of the influence of these factors on the incineration process might help to optimize incinerators with regard to mineralization efficiency of organics. This paper presents a method for investigating the influence of process parameters on mineralization of organics to CO2 by using the elemental carbon (EC) and organic carbon (OC) concentrations in the solid residues as indicators. The results obtained by experiments in full-scale incinerators show that the EC concentration in these residues is a good indicator of oxygen supply, whereas the OC/EC ratio is a good indicator of temperature in and above the furnace bed. Very effective burnout of the bottom ash up to 0.95 g of TOC (EC + OC) per kilogram of dry matter (DM) and of the electrostatic precipitator (ESP) ash up to 0.24 g of TOC per kilogram of DM was achieved in a full-scale incinerator.
Asunto(s)
Carbono/química , Eliminación de Residuos/métodos , Dióxido de Carbono/análisis , Dióxido de Carbono/química , Incineración , Oxidación-Reducción , TemperaturaRESUMEN
Incinerators do not achieve a complete mineralization of organic constituents of municipal solid waste. The solid residues (bottom ash, boiler ash and air pollution control residues) contain carbon which can be determined as total organic carbon (TOC). This work focuses on the TOC composition and its significance to the genesis and diagenesis of the solid residues. An analytical procedure is presented to characterize carbon species by different chemical and microscopic analytical methods. The procedure is based on two steps. In the first step a quantitative classification of TOC into four different carbon species (elemental carbon, water extractable organic carbon, dichloromethane extractable organic carbon and non extractable organic carbon) is performed to obtain a first survey of the TOC composition. Based on this survey a further characterization of individual carbon species is performed. The results of the qualitative and quantitative characterization of carbon species allow to postulate hypotheses on the influence of organic carbon on the long-term behavior of the solid residues.