RESUMEN
Given the importance of energy storage and its hybridization with renewable technologies for the energy transition, the development of redox flow batteries (RFB) is receiving particular attention. Among the various emerging technologies, aqueous organic redox flow batteries (AORFBs) are of particular interest, as the objectives in terms of durability, cost, and safety can be achieved thanks to the possibilities offered by molecular engineering. While anthraquinones have been widely explored as negolytes, few works report the use of naphthoquinones. This work aims to exploit an innovative in situ and cost-effective method for the one-pot synthesis of water-soluble naphthoquinones for application as a negolyte in redox flow batteries. As exemplified with alizarin, the energy of the naphthoquinone synthetic reaction in fuel cell mode can be recovered and the electrolyte solution used directly in redox flow batteries without purification. A 0.3 M naphthoquinone solution paired with 0.6 M ferrocyanide demonstrated good stability compared with other naphthoquinones, with a capacity fade rate of 0.017%/cycle (0.84%/day) over 320 cycles. Additionally, the system exhibited one of the highest energy efficiencies (82%) and a power density of 80-105 mW cm-2 at 50% SOC. These first results are promising for further exploration of new water-soluble naphthoquinones efficiently synthesized from hydroxyanthraquinones for application in AORFBs.
RESUMEN
Electrochemical behaviors of individual carbon fibers coming from carbon felts were investigated using two different redox couples, 1,1'-dimethanolferrocene and potassium ferrocyanide. Electrochemical responses were examined after different oxidation treatments, then simulated and interpreted using the Kissa 1D software and existing models. Our experiments indicate that a crude carbon fiber behaves as an assembly of sites with different electrochemical reactivities. In such case, the Butler-Volmer law is not appropriate to describe the electron transfer kinetics because of the large created overpotential. Oxidation of the fiber erases the effect by increasing the kinetics of the electron transfer probably by a homogenization and increase of the reactivity on all the fiber. Additionally, analysis of the signal shows the large influence of the convection that affects the electrochemical response even at moderate scan rates (typically below 0.1-0.2 V s-1).