RESUMEN

Simultaneous monitoring of glucose and lactate is an important challenge for understanding brain energetics in physiological or pathological states. We demonstrate here a versatile method based on a minimally invasive single implantation in the rat brain. A silicon/SU8-polymer multi-sensing needle-shaped biosensor, was fabricated and tested. The multi-electrode array design comprises three platinum planar microelectrodes with a surface area of 40 × 200 µm(2) and a spacing of 200 µm, which were micromachined on a single 3mm long micro-needle having a 100 × 50 µm(2) cross-section for reduced tissue damage during implantation. Platinum micro-electrodes were aligned at the bottom of micro-wells obtained by photolithography on a SU8 photoresist layer. After clean room processing, each micro-electrode was functionalized inside the micro-wells by means of a micro-dispensing device, either with glucose oxidase or with lactate oxidase, which were cross-linked on the platinum electrodes. The third electrode covered with Bovine Serum Albumin (BSA) was used for the control of non-specific currents. The thick SU8 photoresist layer has revealed excellent electrical insulation of the micro-electrodes and between interconnection lines, and ensured a precise localization and packaging of the sensing enzymes on platinum micro-electrodes. During in vitro calibration with concentrations of analytes in the mM range, the micro-wells patterned in the SU8 photoresist proved to be highly effective in eliminating cross-talk signals, caused by H2O2 diffusion from closely spaced micro-electrodes. Moreover, our biosensor was successfully assayed in the rat cortex for simultaneous monitoring of both glucose and lactate during insulin and glucose administration.

Asunto(s)

RESUMEN

Microelectrode biosensors are a promising technique to probe the brain interstitial fluid and estimate the extracellular concentration of neurotransmitters like glutamate. Their selectivity is largely based on maintaining high substrate specificity for the enzymes immobilized on microelectrodes. However, the effect of enzyme immobilization on substrate specificity is poorly understood. Furthermore, the accuracy of biosensor measurements for brain biological extracts has not been reliably established in comparison with conventional analytical techniques. In this study, microelectrode biosensors were prepared using different enzyme immobilization methods, including glutaraldehyde, a conventional cross-linker, and poly(ethylene glycol) diglycidyl ether (PEGDE), a milder immobilization reagent. Glutaraldehyde, but not PEGDE, significantly decreased the apparent substrate specificity of glutamate and glucose oxidase. For glutaraldehyde prepared biosensors, detection of secondary substrates by glutamate oxidase increased, resulting in a significant overestimate of glutamate levels. This effect was not observed with PEGDE-based biosensors, and when brain microdialysates were analyzed, the levels of glutamate detected by biosensors were consistent with those detected by capillary electrophoresis. In addition, basal concentrations of glutamate detected in vivo were approximately 10-fold lower than the levels detected with glutaraldehyde-based biosensors (e.g., 1.2 µM vs 16 µM, respectively). Overall, enzyme immobilization can significantly impact substrate specificity, and PEGDE is well-suited for the preparation of stable and selective biosensors. This development questions some of the previous biosensor studies aimed at detecting glutamate in the brain and opens new possibilities for specific neurotransmitter detection.

Asunto(s)

RESUMEN

Poly(ethylene glycol) diglycidyl ether (PEGDE) is widely used as an additive for cross-linking polymers bearing amine, hydroxyl, or carboxyl groups. However, the idea of using PEGDE alone for immobilizing proteins on biosensors has never been thoroughly explored. We report the successful fabrication of microelectrode biosensors based on glucose oxidase, d-amino acid oxidase, and glutamate oxidase immobilized using PEGDE. We found that biosensors made with PEGDE exhibited high sensitivity and a response time on the order of seconds, which is sufficient for observing biological processes in vivo. The enzymatic activity on these biosensors was highly stable over several months when they were stored at 4 °C, and over at least 3d at 37 °C. Glucose microelectrode biosensors implanted in the central nervous system of anesthetized rats reliably monitored changes in brain glucose levels induced by sequential administration of insulin and glucose. PEGDE provides a simple, low cost, non-toxic alternative for the preparation of in vivo microelectrode biosensors.

Asunto(s)

RESUMEN

A transient finite-element model has been developed to simulate an extracellular action potential recording in a tissue slice by a planar microelectrode array. The thin-film approximation of the active neuron membrane allows the simulation within single finite-element software of the intracellular and extracellular potential fields. In comparison with a compartmental neuron model, it is shown that the thin-film approximation-based model is able to properly represent the neuron bioelectrical behavior in terms of transmembrane current and potential. Moreover, the model is able to simulate extracellular action potential recordings with properties similar to those observed in biological experiments. It is demonstrated that an ideal measurement system model can be used to represent the recording microelectrode, provided that the electronic recording system adapts to the electrode-tissue interface impedance. By comparing it with a point source approximated neuron, it is also shown that the neuron three-dimensional volume should be taken into account to simulate the extracellular action potential recording. Finally, the influence of the electrode size on the signal amplitude is evaluated. This parameter, together with the microelectrode noise, should be taken into account in order to optimize future microelectrode designs in terms of the signal-to-noise ratio.

Asunto(s)

RESUMEN

The amount of hydrogen present in porous silicon (PS) nanostructures is analyzed in detail. Concentration of atomic hydrogen chemically bound to the specific surface of PS is quantitatively evaluated by means of attenuated total reflection infrared (ATR-IR) spectroscopy and temperature-programmed desorption (TPD) spectroscopy. The concentration values are correlated to the PS nanoscale morphology. In particular, the influence of porosity, silicon nanocrystallite dimension, and shape on hydrogen concentration values is described. Hydrogen concentrations in fresh, aged, as well as in chemically and thermally treated PS layers are measured. Maximal hydrogen concentration of 66 mmol/g is detected in nanoporous layers with high (>95%) porosity consisting of nanocrystallites with dimensions of about 2 nm. Mass energy density that can be potentially obtained from this amount of hydrogen through a low-temperature fuel cell is estimated to be about 2176 W-h/kg and is found to be comparable with other substances containing hydrogen, such as hydride materials and methanol, which are usually used as hydrogen reservoirs.