RESUMEN
PURPOSE: The probability of agglomerate-to-wall collision was quantified using a unique image processing technique applied to high-speed microscopic images. The study aimed to investigate the effects of flow rate and particle size on the percentage of colliding agglomerates detected within an in-house powder dispersion device. METHOD: The device consists of a swirl chamber and two tangential inlets in various configurations, designed to emulate the geometric features of commercial devices such as the Aerolizer® and Osmohaler®. The test cases were conducted with constant flow rates of 30 SLPM and 60 SLPM. Four powder samples were tested, including carrier Respitose® SV010 (median volume diameter 104 µm, span 1.7) and mannitol of three constituent primary particle sizes (3 µm, 5 µm and 7 µm; span 1.6 - 1.9). RESULTS: At the lower flow rate of 30 SLPM, collision frequencies were significantly different between powders of different constituent particle sizes, but the effects of powder properties diminished on increasing the flow rate to 60 SLPM. At the higher flow rate, all powders experienced a significant increase in the proportion of colliding particles. CONCLUSION: Analysis of collision events showed that the probability of collision for each agglomerate increased with agglomerate diameter and velocity. Experimental data of agglomerate-to-wall collision were utilised to develop a logistic regression model that can accurately predict collisions with various powders and flow rates.
Asunto(s)
Inhaladores de Polvo Seco , Manitol , Aerosoles , Polvos , Tamaño de la Partícula , Administración por InhalaciónRESUMEN
The transport of pharmaceutical dry powder inside an optically accessible inhaler-like device is studied using both macro- and microscopic high-speed imaging. The investigation aims to systematically study the effect of inflow modifications on the dispersion characteristics of agglomerates inside a dry powder inhaler (DPI) geometry. An inhaler device was designed with geometrical features akin to commercial inhalers used in the current market and research oriented inhalers such as the Twincer®: two offset inlet channels (one with a powder pocket), a clockwise swirling chamber and a single outlet channel. At the device outlet, a vacuum pump was fitted with an actuator and calibrated to achieve a steady state inhalation with a peak flowrate of 85 and 125 L/min. Airflow conditions at the intake of the device were strategically perturbed in order to induce powder fluidisation and dispersion using turbulence grids and through physically obstructing channel streams in order to achieve changes in flow behaviour (e.g., flow separation). Complete fluidisation of the powder bed was observed with image processing enabling statistics on de-agglomerated fragment size and velocity. A range of behaviour was noted including local turbulence through introduction of a grid, bimodal fragment size behaviour for cohesive mannitol powder, as well as introduction of low velocity zones in the device through flow splitting. The geometry enables simple systematic study of inflow conditions into a DPI-like device with the data being useful for study of a given powder formulation (mannitol) and validation of computational models.