RESUMEN
PURPOSE:: The purpose of this study was to evaluate the effects of four in-office desensitizing products on dentin tubule occlusion and erosive wear. METHODS:: Dentin hypersensitivity was simulated by EDTA application for five minutes. The specimens were randomly allocated into five groups (n=11), according to treatment: No treatment - Control (C), Duraphat (DUR), Desensibilize Nano P (NP), ClinPro XT Varnish (XTV), and ClinPro White Varnish (CWV). They were then submitted to erosive/abrasive cycling for five days. After EDTA, treatment, and cycling, the specimens were analyzed with an environmental scanning electron microscope (ESEM) to verify the number of opened dentin tubules (ODT) which were counted by using ImageJ software, and with a profilometer to determine the surface curvature/loss. ESEM data were analyzed with two-way repeated measure analysis of variance and Tukey tests. For the profilometer, data were analyzed with Kruskal-Wallis, Tukey, and Mann-Whitney tests. RESULTS:: After treatment, all groups showed lower ODT than the control, without significant differences between them. After cycling, the only group that showed lower ODT than the control was group XTV; however, it did not significantly differ from the other groups. For the profilometric analysis, there were significant differences in SL between the experimental times after treatment and after cycling for all groups ( p<0.05). After cycling, no surface loss was detected in groups DUR and XTV, which presented a significantly different curvature than group NP and the control group, but not from group CWV. Surface loss was detected for the control and groups NP and CWV, without difference among them. CONCLUSION:: All desensitizing agents tested presented promising results concerning the obliteration of dentin tubules immediately after treatment. XTV was the only desensitizer capable of preventing the reopening of the tubules after the erosive/abrasive challenges. XTV and DUR presented a protective effect against dentin erosive wear.
Asunto(s)
Desensibilizantes Dentinarios , Sensibilidad de la Dentina , Desgaste de los Dientes , Dentina , Humanos , Microscopía Electrónica de RastreoRESUMEN
To evaluate the effect of Er,Cr:YSGG laser, associated with fluoride application, on the prevention/control of dentin erosion. Dentin slabs were embedded in acrylic resin, flattened, and polished. Half of the specimens were previously eroded (10 min immersion in 1% citric acid solution) and half were kept sound. The specimens (n = 10 each substrate) were randomly allocated into the experimental groups, according to the following treatments: control (no treatment); APF gel (1.23% F, 1 min); Er,Cr:YSGG laser irradiation (P1: 0.25 W, 20 Hz, 2.8 J/cm2, tip S75, beam diameter of 750 µm, 1 mm away from the surface); Er,Cr:YSGG laser irradiation (P2: 0.50 W, 20 Hz, 5.7 J/cm2, tip S75, beam diameter of 750 µm, 1 mm away from the surface); APF gel + Er,Cr:YSGG laser P1 and; APF gel + Er,Cr:YSGG laser P2. Afterwards, the specimens underwent an erosion-remineralization cycling, consisting of a 5-min immersion into 0.3% citric acid, followed by 60-min exposure to artificial saliva. This procedure was repeated 4×/day, for 5 days. Surface loss (SL, in µm) was determined by optical profilometry. Specimens from each group were analyzed by environmental scanning electron microscopy (n = 3). Data were statistically analyzed (α = 0.05). For the eroded specimens, APF gel presented the lowest SL, being different from the control. For the sound specimens, none of the groups differed from the control, except for Er,Cr:YSGG laser P2, which presented the highest SL. When substrates were compared, only the eroded specimens of the control and APF + Er,Cr:YSGG laser P1 Groups showed higher SL. Selective structure removal was observed for the laser-treated groups. None of the Er,Cr:YSGG laser parameters were effective in the prevention/control dentin erosion. The laser was also unable to enhance the protection of fluoride against dentin erosion.
Asunto(s)
Fluoruro de Fosfato Acidulado/uso terapéutico , Dentina/efectos de los fármacos , Progresión de la Enfermedad , Láseres de Estado Sólido/uso terapéutico , Erosión de los Dientes/tratamiento farmacológico , Erosión de los Dientes/prevención & control , Animales , Bovinos , Dentina/ultraestructura , Microscopía Electrónica de RastreoRESUMEN
Determining the factors associated with NCCLs and DH in populations could guide the implementation of specific preventive measures. This study evaluated the clinical features and factors associated with non-carious cervical lesions (NCCLs) and dentin hypersensitivity (DH) in a Brazilian population. The participants were 118 patients at the Dentistry Clinic of our dental school. They completed an interview to obtain personal information and determine the possible factors associated with NCCLs and DH. Clinical examination was undertaken to record the NCCLs, shape of the lesion and certain occlusal factors. DH was diagnosed by air and probe tests. Data were analysed with the multilevel Poisson regression and prevalence ratios, and the respective 95% confidence intervals were calculated. The prevalence of NCCLs and DH among patients was 67·8% and 51·7%, respectively. Of a total number of 2902 teeth examined, 9·65% had NCCLs and 5·82% were sensitive to air. The most affected teeth for both conditions were the premolars. Most of the NCCLs were wedge-shaped and located in the maxilla. The factors associated with NCCLs and DH were age and presence of premature occlusal contacts. NCCLs were also significantly associated with consumption of wine and alcoholic beverages, and DH with consumption of acidic fruits and juices. NCCLs were a common finding, with higher frequency in more advanced age groups, the maxilla and premolars. A significant association occurred between NCCLs, premature contacts and consumption of wine and alcoholic beverages. DH was associated with NCCLs, premature contacts and with the consumption of acidic fruits and juices.
Asunto(s)
Bebidas Alcohólicas/efectos adversos , Citrus/efectos adversos , Sensibilidad de la Dentina/patología , Cuello del Diente/patología , Erosión de los Dientes/patología , Adolescente , Adulto , Brasil/epidemiología , Estudios Transversales , Sensibilidad de la Dentina/epidemiología , Sensibilidad de la Dentina/prevención & control , Femenino , Conocimientos, Actitudes y Práctica en Salud , Humanos , Masculino , Persona de Mediana Edad , Prevalencia , Factores de Riesgo , Erosión de los Dientes/epidemiología , Cepillado Dental/métodos , Adulto JovenRESUMEN
This study aimed to evaluate the efficacy of piroxicam associated with low-level laser therapy compared with single therapies in 32 patients presenting temporomandibular joint arthralgia in a random and double-blind research design. The sample, divided into laser + piroxicam, laser + placebo piroxicam and placebo laser + piroxicam groups, was submitted to the treatment with infrared laser (830 nm, 100 mW, 28 s, 100 J cm(-2) ) at 10 temporomandibular joint and muscle points on each side during four sessions concomitant to take one capsule a day of piroxicam 20 mg during 10 days. The treatment was evaluated throughout four sessions and 30 days follow-up through visual analogue scale (VAS), maximum mouth opening and joint and muscle (temporal and masseter) pain on palpation. The results showed that all the study groups had a significant improvement in the VAS scores (P < 0·05), and there were no significant group differences. Piroxicam was effective in the reduction of joint and muscle pain on palpation (P < 0·05) and showed the lowest temporal pain (P = 0·02) at the 30-day follow-up. The combination of low-level laser therapy and piroxicam was not more effective than single therapies in the treatment of temporomandibular joint arthralgia. The use of piroxicam was more effective in the following 30 days.