RESUMEN
Fine-tuning of grain sizes can significantly influence the interaction between different dielectric phenomena, allowing the development of materials with tailored dielectric resistivity. By virtue of various synthesis mechanisms, a pathway to manipulate grain sizes and, consequently, tune the material's dielectric response is revealed. Understanding these intricate relationships between granulation and dielectric properties can pave the way for designing and optimizing materials for specific applications where tailored dielectric responses are sought. The experimental part involved the fabrication of dense BCT-BZT ceramics with different grain sizes by varying the synthesis (conventional solid-state reaction route and sol-gel) and consolidation methods. Both consolidation methods produced well-crystallized specimens, with Ba0.85Ca0.15O3Ti0.9Zr0.1 (BCTZ) perovskite as the major phase. Conventional sintering resulted in microstructured and submicron-structured BCT-BZT ceramics, with average grain sizes of 2.35 µm for the solid-state sample and 0.91 µm for the sol-gel synthesized ceramic. However, spark plasma sintering produced a nanocrystalline specimen with an average grain size of 67.5 nm. As the grain size decreases, there is a noticeable decrease in the maximum permittivity, a significant reduction in dielectric losses, and a shifting of the Curie temperature towards lower values.
RESUMEN
Structural and electrical properties of epitaxial Pb(Zr0.2Ti0.8)O3 films grown by pulsed laser deposition from targets with different purities are investigated in this study. One target was produced in-house by using high purity precursor oxides (at least 99.99%), and the other target was a commercial product (99.9% purity). It was found that the out-of-plane lattice constant is about 0.15% larger and the a domains amount is lower for the film grown from the commercial target. The polarization value is slightly lower, the dielectric constant is larger, and the height of the potential barrier at the electrode interfaces is larger for the film deposited from the pure target. The differences are attributed to the accidental impurities, with a larger amount in the commercial target as revealed by composition analysis using inductive coupling plasma-mass spectrometry. The heterovalent impurities can act as donors or acceptors, modifying the electronic characteristics. Thus, mastering impurities is a prerequisite for obtaining reliable and reproducible properties and advancing towards all ferroelectric devices.
RESUMEN
Lead titanate (PT) ceramics co-doped with 8 to 13 mol% Ni-Nb, by substituting titanium ions, were prepared by conventional ceramic method and the influence of Ni-Nb doping level on their morpho-structural, electromechanical and dielectric properties was investigated. Dense tetragonal PT ceramics were obtained for 8 to 12 mol% Ni-Nb co-doping. Lattice anisotropy decreased from 1.053 to 1.046 with increasing doping level. Large thickness coupling factors of 0.4 were obtained for 8, 11, and 12 mol% Ni-Nb. Large electromechanical anisotropy of 10 was obtained for 8 mol% Ni-Nb. It was found that Ni-Nb co-doping has both softening and hardening effects as a function of donor or acceptor behavior of different amounts of Ni-Nb. For 13 mol% Ni-Nb, segregation of a small amount of a secondary phase occurs, lattice constants and tetragonality significantly decrease and the resulting ceramic becomes very hard.