RESUMEN

A promising scheme for the remote detection of nitrate-based explosives, which have low vapor pressure, involves two lasers: the first to desorb, vaporize, and photofragment the explosive molecule and the second to create laser-induced fluorescence in the NO fragment. It is desirable to use for the first a powerful 532 nm frequency-doubled Nd:YAG laser. In this study, we investigate the degree of photofragmentation into NO resulting from the irradiation of the explosives RDX and HMX coated on a variety of surfaces. The desorption step is followed by femtosecond laser ionization and time-of-flight mass spectrometry to reveal the fragments produced in the first step. We find that modest laser power of 532 nm desorbs the explosive and produces adequate amounts of NO.

RESUMEN

The photodetachment of the O(2)(-).H(2)O cluster anion at 780 and 390 nm is investigated in comparison with O(2)(-) using photoelectron imaging spectroscopy. Despite the pronounced shift in the photoelectron spectra, the monohydration has little effect on the photoelectron angular distributions: for a given wavelength and electron kinetic energy (eKE) range, the O(2)(-).H(2)O angular distributions are quantitatively similar to those for bare O(2)(-). This observation confirms that the excess electron in O(2)(-).H(2)O retains the overall character of the 2ppi(g) HOMO of O(2)(-). The presence of H(2)O does not affect significantly the partial wave composition of the photodetached electrons at a given eKE. An exception is observed for slow electrons, where O(2)(-).H(2)O exhibits a faster rise in the photodetachment signal with increasing eKE, as compared to O(2)(-). The possible causes of this anomaly are (i) the long-range charge-dipole interaction between the departing electron and the neutral O(2).H(2)O skeleton affecting the slow-electron dynamics; and (ii) the s wave contributions to the photodetachment, which are dipole-forbidden for pi(g)(-1) transitions in O(2)(-), but formally allowed in O(2)(-).H(2)O due to lower symmetry of the cluster anion and the corresponding HOMO.

Asunto(s)

RESUMEN

The energy-resolved competitive collision-induced dissociation of the proton-bound complex [HS.H.CN](-) is studied in a guided ion beam tandem mass spectrometer. H(2)S and HCN have nearly identical gas-phase acidities, and therefore, the HS(-) + HCN and the CN(-) + H(2)S product channels exhibit nearly the same threshold energies, as expected. However, the HS(-) + HCN channel has a cross section up to a factor of 50 larger than CN(-) + H(2)S at higher energies. The cross sections are modeled using RRKM theory and phase space theory. The complex dissociates to HS(-)+ HCN via a loose transition state, and it dissociates to CN(-) + H(2)S via a tight transition state. Theoretical calculations show that the proton-transfer potential energy surface has a single minimum and that the hydrogen bonding in the complex is strongly unsymmetrical, with an ion-molecule complex of the form HS(-)..HCN rather than CN(-)..H(2)S or an intermediate structure. The requirement for proton transfer before dissociation and curvature along the reaction path impedes the CN(-) + H(2)S product channel.

RESUMEN

The photoelectron spectra of NiCN-, PdCN-, PtCN-, HNiC2H-, Ni(C2H)2(-), PdC2H-, and PtC2H- are presented along with density functional theory calculations. Linear structures are predicted for all anions and neutrals. NiCN- and NiCN are predicted to have 3delta and 2delta ground states, respectively. HNiC2H- and Ni(C2H)2(-) are predicted to have 2delta and 2delta(g) anion and 3delta and 3pi(g) neutral ground states, respectively. The palladium and platinum cyanide and acetylides have 1sigma+ anion and 2sigma+ neutral ground states. Simulations generated from the calculated parameters are compared to observed spectra, and molecular orbital diagrams are presented to compare the bonding in these species.

RESUMEN

Density functional theory calculations (Becke's three parameter hybrid functional) have been done on a wide range of possible structures for the complexes formed in the reaction between Al(3)O(3) (-) and one or two water molecules. Both energetically competitive structural isomers of Al(3)O(3) (-) (kitelike and distorted rectangle) were considered. The structures of neutral complexes accessed from detachment of the stable anion structures were also optimized. The calculations predict that hydroxide complexes are energetically favored over Lewis acid-base and charge-dipole complexes. For Al(3)O(3) (-)/H(2)O complexes, the kite-based hydroxide and rectangle-based hydroxide are predicted to be nearly isoenergetic, while for Al(3)O(3) (-)/(H(2)O)(2), the rectangle-based dihydroxide emerges as being 0.5 eV more stable than the lowest energy kite-based dihydroxide. The structures of these and their neutrals are used to analyze anion PE spectra of Al(3)O(4)H(2) (-) and Al(3)O(5)H(4) (-) obtained previously [F. A. Akin and C. C. Jarrold, J. Chem. Phys. 118, 5841 (2003)].

RESUMEN

Various surface modifications have been applied to titanium alloy (Ti-6Al-4V) implants, in an attempt to enhance osseointegration; crucial for ideal prosthetic fixation. Despite the numerous studies demonstrating that peptide-modified surfaces influence in vitro cellular behavior, there is relatively little data reporting their effects on bone remodeling. The objective of this article was to examine the effects of chemically modifying Ti-6Al-4V surfaces with a common RGD sequence, a 15-residue peptide containing GRGDSP (glycine-arginine-glycine-aspartate-serine-proline), on the modulation of bone remodeling. The expression of proteins known to be associated with osseous matrix and bone resorption were studied during the growth of human bone-derived cells (HBDC) on these peptide-modified surfaces. HBDC grown for 7 days on RGD surfaces displayed significantly increased levels of osteocalcin, and pro-collagen Ialpha1 mRNAs, compared with the production by HBDC grown on the native Ti-6Al-4V. A pattern that was also reflected at the protein levels for osteocalcin, type I collagen, and bone sialoprotein. Moreover, HBDC grown for 7 and 14 days on RGD-modified Ti-6Al-4V expressed significantly higher level of osteoclast differentiation factors and lower levels of osteoprotegerin and IL-6 proteins compared with other surfaces tested. These results suggest that different chemical treatments of implant material (Ti-6Al-4V) surface result in differential bone responses, not only their ability to form bone but also to stimulate osteoclastic formation.

Asunto(s)